DatasheetsPDF.com

MPL115A1 Datasheet PDF


Part Number MPL115A1
Manufacturer NXP
Title Miniature SPI digital barometer
Description The MPL115A1 is an absolute pressure sensor with a digital SPI output targeting low-cost applications. A miniature 5 x 3 x 1.2 mm LGA package is i...
Features
• Digitized pressure and temperature information together with programmed calibration coefficients for host micro use.
• Factory calibrated
• 50 kPa to 115 kPa absolute pressure
• ±1 kPa accuracy
• 2.375 V to 5.5 V supply
• Integrated ADC
• SPI Interface
• Monotonic pressure and temperature data out...

File Size 436.88KB
Datasheet MPL115A1 PDF File








Similar Ai Datasheet

MPL115A1 : PIN 1 2 MPL115A1 5.0 mm X 3.0 mm X 1.2 mm MAX VDD CAP GND SHDN 1 2 3 4 8 7 6 5 SCLK DIN DOUT CS NAME VDD CAP GND SHDN CS DOUT DIN SCLK FUNCTION VDD Power Supply Connection. External Capacitor Ground Shutdown (Sleep): Connect to GND to disable the device. When in shut down the part draws 1μA supply current CS: SPI Chip Select line. DOUT: Serial data output. DIN: Serial data input. SPI Serial Clock Input. 3 4 5 6 7 8 PIN CONNECTIONS © Freescale Semiconductor, Inc., 2009. All rights reserved. Pressure Maximum Ratings www.DataSheet4U.com Voltage (with respect to GND unless otherwise noted) VDD .....

MPL115A2 : The MPL115A2 is an absolute pressure sensor with a digital I2C output targeting low-cost applications. A miniature 5 x 3 x 1.2 mm LGA package is ideally suited for the space constrained requirements of portable electronic devices. Low current consumptions of 5 μA during Active mode and 1 μA during Shutdown (Sleep) mode are essential when focusing on low-power applications. The wide operating temperature range spans from –40 °C to +105 °C to fit demanding environmental conditions. The MPL115A2 employs a MEMS pressure sensor with a conditioning IC to provide accurate pressure measurements from 50 kPa to 115 kPa. An integrated ADC converts pressure and temperature sensor readings to digitized o.

MPL115A2 : Diff Amp Temp Sensor MUX Coefficient Storage ADDR ADDR ADDR ADC ADDR Pressure ADDR Temperature I2C Interface VDD VDD 1 μF CAP CAP 1 μF SSHHDDNN SCL SCL SDA SDA RST RST 4.7 k 4.7 k GND GND μC Microcontroller Table 1. Pin Description Figure 1. Block Diagram and Pin Connections Pin Name Function 1 VDD VDD Power Supply Connection: VDD range is 2.375V to 5.5V. 2 CAP 1 μF connected to ground. 3 GND Ground Shutdown: Connect to GND to disable the device. When in shutdown, the part draws no more than 1 μA supply 4 SHDN current and all communications pins (RST, SCL, SDA) are high impedance. Connect to VDD for normal operation. 5 RST Reset: Connect to ground to dis.




Since 2006. D4U Semicon,
Electronic Components Datasheet Search Site. (Privacy Policy & Contact)