54AC11253, 74AC11253 DUAL 1-OF-4 DATA SELECTORS/MULTIPLEXERS
WITH 3-STATE OUTPUTS
SCAS041A – MAY 1988 – REVISED APRIL 19...
54AC11253, 74AC11253 DUAL 1-OF-4 DATA SELECTORS/MULTIPLEXERS
WITH 3-STATE OUTPUTS
SCAS041A – MAY 1988 – REVISED APRIL 1993
Permits Multiplexing From N Lines to
One Line
Performs Parallel-to-Serial Conversion Flow-Through Architecture Optimizes
PCB Layout
Center-Pin VCC and GND Configurations
Minimize High-Speed Switching Noise
t EPIC (Enhanced-Performance Implanted
CMOS) 1-mm Process
Package Options Include Plastic Small-
Outline Packages, Ceramic Chip Carriers,
and Standard Plastic and Ceramic 300-mil
DIPs
54AC11253 . . . J PACKAGE 74AC11253 . . . D OR N PACKAGE
(TOP VIEW)
A B 1Y GND 2Y 1G 2G 2C3
1 2 3 4 5 6 7 8
16 1C0 15 1C1 14 1C2 13 1C3 12 VCC 11 2C0 10 2C1 9 2C2
54AC11253 . . . FK PACKAGE (TOP VIEW)
description
1C2 1C3 NC V CC 2C0
Each of these data selectors/multiplexers contains inverters and drivers to supply full binary decoding data selection to the AND-OR gates. Separate output control inputs are provided for each of the two four-line sections.
The three-state outputs can interface with and drive data lines of bus-organized systems. With all but one of the common outputs disabled (at a high-impedance state), the low-impedance of the single enabled output will drive the bus line to a high or low logic level. Each output has its own strobe (G). The output is disabled when its strobe is high.
The 54AC11253 is characterized for operation over the full military temperature range of – 55°C to 125°C. The 74AC11253 is characterized for operation from – ...