A3520

www.DataSheet4U.com a3520 general features The a3520 is a DC motor controller IC, providing a single chip solution for a wide range of tasks including power supply, motor control and high level system control. The IC's components enable parallel execution of system functions such as PWM input capture, current limit monitoring, bridge clock generation, etc., while reducing the IC's MCU's load and memory requirements. IC Features  Operating VCC range from 5-18V  On-chip 25MHz ±1% oscillator  10bit AD Converter with 8-channel multiplexer  On-chip 3.3V/5mA regulator  On-chip programmable 0.7V to 2.7V/10mA regulator, suitable for driving passive hall elements  VCC monitor  On-chip temperature sensor  6 gate driver outputs with pull and dump resistors  PWM input capture unit to decode duty cycles of external signals  Open drain signal output, over current protected  Two wire interface  0-VCC high voltage PWM-output ready to drive inrush current protection transistors  Up to 10 pins usable as GPIO  Spread spectrum PWM support via software  Non-overlapping bridge clock generator with programmable deadtime  Programmable current limit  analog comparator with programmable hysteresis (Hall sensor, Phase voltage feedback) MCU Features  Standard compatible MCU  Powerful single cycle instruction set (only RAM access and branches need two cycles)  25MHz MCU clock  12 prioritized interrupt levels  256Byte RAM  4kByte Pseudo-MTP program memory  Four 16bit timers with p...