DatasheetsPDF.com

AD600 Datasheet

Part Number AD600
Manufacturers Analog Devices
Logo Analog Devices
Description Variable Gain Amplifiers
Datasheet AD600 DatasheetAD600 Datasheet (PDF)

FEATURES 2 channels with independent gain control Linear in dB gain response 2 gain ranges AD600: 0 dB to 40 dB AD602: –10 dB to +30 dB Accurate absolute gain: ±0.3 dB Low input noise: 1.4 nV/√Hz Low distortion: −60 dBc THD at ±1 V output High bandwidth: dc to 35 MHz (−3 dB) Stable group delay: ±2 ns Low power: 125 mW (maximum) per amplifier Signal gating function for each amplifier Drive high speed ADCs MIL-STD-883-compliant and DESC versions available APPLICATIONS Ultrasound and sonar time-gai.

  AD600   AD600






Part Number AD60D60
Manufacturers AP Semiconductor
Logo AP Semiconductor
Description 60V 60A Ultra Low VF Schottky
Datasheet AD600 DatasheetAD60D60 Datasheet (PDF)

AD60D60 60V 60A Ultra Low VF Schottky Characteristics Summary Characteristics Values IF(AV) 30 X 2 VRRM VFBC @ 15A, TJ = 25℃ TJ Operating Junction Temperature 60 0.50 -65 to +150 Units A V V, typ. ℃ Features ◼ Ultra Low Forward Voltage ( VF ) Drop ◼ Very Low Reverse Leakage in high temperature. ◼ Softest, fast switching capability ◼ 150℃ Operating Junction Temperature ◼ Lead Free Finish, RoHS Compliant AD60D60TF TO-247 PIN2 PIN3 Case PIN1 Typical Applications Device optimized for.

  AD600   AD600







Part Number AD608
Manufacturers Analog Devices
Logo Analog Devices
Description Low Power Mixer/Limiter/RSSI 3 V Receiver IF Subsystem
Datasheet AD600 DatasheetAD608 Datasheet (PDF)

Low Power Mixer/Limiter/RSSI 3 V Receiver IF Subsystem AD608 FEATURES Mixer −15 dBm, 1 dB compression point −5 dBm IP3 24 dB conversion gain >500 MHz input bandwidth Logarithmic/limiting amplifier 80 dB RSSI range ±3° phase stability over 80 dB range Low power 21 mW at 3 V power consumption CMOS-compatible power-down to 300 μW typical 200 ns enable/disable time APPLICATIONS PHS, GSM, TDMA, FM, or PM receivers Battery-powered instrumentation Base station RSSI measurements GENERAL DESCRIPTION The.

  AD600   AD600







Part Number AD607
Manufacturers Analog Devices
Logo Analog Devices
Description Low Power Mixer/AGC/RSSI 3 V Receiver IF Subsystem
Datasheet AD600 DatasheetAD607 Datasheet (PDF)

a FEATURES Complete Receiver on a Chip: Monoceiver™ Mixer –15 dBm 1 dB Compression Point –8 dBm Input Third Order Intercept 500 MHz RF and LO Bandwidths Linear IF Amplifier Linear-in-dB Gain Control MGC or AGC with RSSI Output Quadrature Demodulator On-Board Phase-Locked Quadrature Oscillator Demodulates IFs from 400 kHz to 12 MHz Can Also Demodulate AM, CW, SSB Low Power 25 mW at 3 V CMOS Compatible Power-Down Interfaces to AD7013 and AD7015 Baseband Converters APPLICATIONS GSM, CDMA, TDMA, and.

  AD600   AD600







Part Number AD606
Manufacturers Analog Devices
Logo Analog Devices
Description 80 dB Demodulating Logarithmic Amplifier
Datasheet AD600 DatasheetAD606 Datasheet (PDF)

a 50 MHz, 80 dB Demodulating Logarithmic Amplifier with Limiter Output AD606 FEATURES Logarithmic Amplifier Performance –75 dBm to +5 dBm Dynamic Range ≤1.5 nV/√Hz Input Noise Usable to >50 MHz 37.5 mV/dB Voltage Output On-Chip Low-Pass Output Filter Limiter Performance ؎1 dB Output Flatness over 80 dB Range ؎3؇ Phase Stability at 10.7 MHz over 80 dB Range Adjustable Output Amplitude Low Power +5 V Single Supply Operation 65 mW Typical Power Consumption CMOS-Compatible Power-Down to 325 ␮W typ.

  AD600   AD600







Part Number AD605
Manufacturers Analog Devices
Logo Analog Devices
Description Dual/ Low Noise/ Single-Supply Variable Gain Amplifier
Datasheet AD600 DatasheetAD605 Datasheet (PDF)

www.DataSheet4U.com a FEATURES Two Independent Linear-in-dB Channels Input Noise at Maximum Gain: 1.8 nV/ √Hz , 2.7 pA/√Hz Bandwidth: 40 MHz (–3 dB) Differential Input Absolute Gain Range Programmable: –14 dB to +34 dB (FBK Shorted to OUT) Through 0 dB to +48 dB (FBK Open) Variable Gain Scaling: 20 dB/V Through 40 dB/V Stable Gain with Temperature and Supply Variations Single-Ended Unipolar Gain Control Output Common-Mode Independently Set Power Shutdown at Lower End of Gain Control Single 5 V .

  AD600   AD600







Variable Gain Amplifiers

FEATURES 2 channels with independent gain control Linear in dB gain response 2 gain ranges AD600: 0 dB to 40 dB AD602: –10 dB to +30 dB Accurate absolute gain: ±0.3 dB Low input noise: 1.4 nV/√Hz Low distortion: −60 dBc THD at ±1 V output High bandwidth: dc to 35 MHz (−3 dB) Stable group delay: ±2 ns Low power: 125 mW (maximum) per amplifier Signal gating function for each amplifier Drive high speed ADCs MIL-STD-883-compliant and DESC versions available APPLICATIONS Ultrasound and sonar time-gain controls High performance audio and RF AGC systems Signal measurement GENERAL DESCRIPTION The AD600/AD6021 dual-channel, low noise, variable gain amplifiers are optimized for use in ultrasound imaging systems but are applicable to any application requiring precise gain, low noise and distortion, and wide bandwidth. Each independent channel provides a gain of 0 dB to +40 dB in the AD600 and −10 dB to +30 dB in the AD602. The lower gain of the AD602 results in an improved signal-to-noise ratio (SNR) at the output. However, both products have the same 1.4 nV/√Hz input noise spectral density. The decibel gain is directly proportional to the control voltage, accurately calibrated, and supply and temperature stable. To achieve the difficult performance objectives, a proprietary circuit form, the X-AMP®, was developed. Each channel of the X-AMP comprises a variable attenuator of 0 dB to −42.14 dB followed by a high speed fixed gain amplifier. In this way, the amplifier never has to cope wit.


2005-03-23 : 2N2857CSM    2N2880    2N2891    2N2894    2N2894    2N2894    2N2894A    2N2894ACSM    2N2894CSM    2N2894DCSM   


@ 2014 :: Datasheetspdf.com ::
Semiconductors datasheet search & download site (Privacy Policy & Contact)