bq24140
www.ti.com
SLUSAO5 – OCTOBER 2011
Fully Integrated Dual-Input Switch-Mode One-Cell Li-Ion Charger with Full U...
bq24140
www.ti.com
SLUSAO5 – OCTOBER 2011
Fully Integrated Dual-Input Switch-Mode One-Cell Li-Ion Charger with Full USB
Compliance and USB-OTG Support
Check for Samples: bq24140
FEATURES
1
High-Efficiency Mini-USB/AC Battery Charger for Single-Cell Li-Ion and Li-Polymer Battery Packs
Charge Battery and Provide USB-OTG Support at the Same Time
High-Accuracy
Voltage and Current Regulation – Input Current Regulation Accuracy: ±5% (100mA, 500mA) – Charge
Voltage Regulation Accuracy: ±0.5% (25°C), ±1% (0-125°C) – Charge Current Regulation Accuracy: ±5%
Boost Mode Operation for USB OTG: – Input
Voltage Range (from Battery): 2.3V to 4.5V – Output for VBUS: 5.05V/500 mA
Input
Voltage Based Dynamic Power Management Provides Protection Against Current Limited Adapters
Bad Adaptor Detection and Rejection Safety Limit Register for Added Security by
Limiting Maximum Charge
Voltage and Maximum Charge Current 20-V Absolute Maximum Input
Voltage Rating 9.0-V Maximum Operating Input
Voltage Charge Faster than Linear Chargers Built-in Input Current Sensing and Limiting Integrated Power FETs for up to 1.5-A Charge Rate
Programmable Charge Parameters Through I2C Interface (up to 3.4 Mbps): – Input Current – Fast-Charge/Termination Current – Charge
Voltage (3.5-4.44V) – Safety Timer with Reset Control – Safety Timer with Reset Control – Termination Enable
Synchronous Fixed-Frequency PWM Controller Operating at 3 MHz With 0% to 99.5% Duty Cycle
Automatic High I...