DIN-50A

±50 A DIN RAIL-MOUNTABLE CURRENT SENSORS GENERAL DESCRIPTION The ModuLink ±50A isolated current sensors are easyto-use devices, tailored for power electronics applications. When employed with imperix’s BoomBox control platform, the sensors provide plug&play connectivity and can be directly powered by the control platform. The devices produce a balanced full-differential output signal, proportional to the current voltage. For best EMC performance, the output signal is typically meant to be carried by a shielded twisted pair embedded in RJ45-type cables. Modulink sensors can be easily clipped on 35mm DIN rails and are compatible with up to 6 mm2 wires. They guarantee the galvanic isolation of the sensing circuit up to 1 kVRMS KEY FEATURES AND SPECIFICATIONS –– ± 50 A measuring range –– 0.2-6mm2 conductor cross-section (AWG 10-24) –– Minimum 200 kHz measurement bandwidth –– Balanced full-differential signal output –– Typical sensitivity of 99.0 mV/A –– 1.0 kVPK galvanic isolation (permanent) –– ± 0.45 % typical precision –– Compatible with standard ± 15 V power supplies –– Mountable on 35 mm DIN rails I+ 2000:1 LAH 50-P I- R GND 1 VCC power supplies, 2 lters 3 VCC GND VCC 4 VO+ 5 VO- VEE 6 GND 7 VEE 8 VEE BOOMBOX CONFIGURATION The recommended configuration for the BoomBox is shown in Table 1 : Sensitivity 99.0 mV/A Filter Gain Filter = NONE G= 2 Input High-impedance Table 1.  Suggested configuration of the BoomBox Imperix recommends to consider calibrating ...