( DataSheet : www.DataSheet4U.com )
TECHNICAL DATA
IN5851
PULSE DIALER WITH REDIAL
The IN5851 is a monolithic CMOS in...
( DataSheet : www.DataSheet4U.com )
TECHNICAL DATA
IN5851
PULSE DIALER WITH REDIAL
The IN5851 is a monolithic
CMOS integrated circuit which uses an inexpensive RC oscillator for its frequency reference and provides all the features required for implementing a pulse dialer with 32 digit redial. Wide operating
voltage range (2.0~6.0V) Low power dissipation Use either a standard 2 of 7 matrix keyboard with negative true common or the inexpensive form A-type keyboard Make/Break ratio can be selected Redial with * or # Continuous MUTE Power up clear circuitry on chip 10 pps/20 pps can be selected
ORDERING INFORMATION IN5851N Plastic TA = -20° to 70° C
LOGIC DIAGRAM
PIN ASSIGNMENT
PIN 1 = VCC PIN 6 = GND
www.DataSheet4U.com
1
www.DataSheet4U.com
IN5851N
PIN DESCRIPTION
NAME VCC PIN 1 Positive supply pin. The
voltage on this pin is measured relative to Pin 6 and is supplied from a 150µA current source. This
voltage should be regulated to less than 6.0 volts using on external form or regulation. VREF 2 The VREF output provides reference
voltage that tracks internal parameters of the IN5851N. VREF provides a negative
voltage reference to the VCC supply. Its magnitude will be approximately 0.6 volt higher than the minimum operating
voltage of each particular IN5851N. The typical application would be to connect the VREF pin to the GND pin (Pin 6). The supply to the VCC pin (Pin 1) should then be regulated to 150µA (IOP max). with this amount of supply current, ...