Rectifier. MBRB2535CTL Datasheet

MBRB2535CTL Datasheet PDF

Part MBRB2535CTL
Description Power Rectifier
Feature MOTOROLA Designer's SEMICONDUCTOR TECHNICAL DATA Order this document by MBRB2535CTL/D ™ Data Shee.
Manufacture Motorola
Datasheet
Download MBRB2535CTL Datasheet

MOTOROLA Designer's SEMICONDUCTOR TECHNICAL DATA Order thi MBRB2535CTL Datasheet
Schottky Barrier Rectifier FEATURES ·With TO-263 packaging MBRB2535CTL Datasheet
MBRB2535CTL Technical Data Data Sheet N0788, Rev. A MBRB2535 MBRB2535CTL Datasheet
MBRB2535CTLG, NRVBB2535CTLG Preferred Device SWITCHMODE Powe MBRB2535CTLG Datasheet




MBRB2535CTL
MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
Order this document
by MBRB2535CTL/D
Designer's Data Sheet
SWITCHMODEPower Rectifier
D2PAK Surface Mount Power Package
MBRB2535CTL
Motorola Preferred Device
The D2PAK Power Rectifier employs the Schottky Barrier principle in a large
metal–to–silicon power diode. State–of–the–art geometry features epitaxial
construction with oxide passivation and metal overlay contact. Ideally suited for
use in low voltage, high frequency switching power supplies, free wheeling
diodes, and polarity protection diodes. These state–of–the–art devices have the
following features:
Center–Tap Configuration
Guardring for Stress Protection
Low Forward Voltage
125°C Operating Junction Temperature
Epoxy Meets UL94, VO at 1/8
Guaranteed Reverse Avalanche
Short Heat Sink Tab Manufactured — Not Sheared!
Similar in Size to the Industry Standard TO–220 Package
1
3
4
SCHOTTKY BARRIER
RECTIFIER
25 AMPERES
35 VOLTS
1
3
4
Mechanical Characteristics
Case: Epoxy, Molded
CASE 418B–02
D2PAK
Weight: 1.7 grams (approximately)
Finish: All External Surfaces Corrosion Resistant and Terminal Leads are Readily Solderable
Lead and Mounting Surface Temperature for Soldering Purposes: 260°C Max. for 10 Seconds
Shipped 50 units per plastic tube
Available in 24 mm Tape and Reel, 800 units per 13reel by adding a “T4” suffix to the part number
Marking: B2535L
MAXIMUM RATINGS (PER LEG)
Rating
Symbol
Value
Unit
Peak Repetitive Reverse Voltage
Working Peak Reverse Voltage
DC Blocking Voltage
Average Rectified Forward Current
(Rated VR) TC = 110°C
Peak Repetitive Forward Current
(Rated VR, Square Wave, 20 kHz), TC = 90°C
Nonrepetitive Peak Surge Current
(Surge applied at rated load conditions halfwave, single phase, 60 Hz)
VRRM 35 Volts
VRWM
VR
IF(AV) 12.5 Amps
IFRM
25 Amps
IFSM
150 Amps
Peak Repetitive Reverse Surge Current (2.0 µs, 1.0 kHz)
Storage Temperature
Operating Junction Temperature
Voltage Rate of Change (Rated VR)
THERMAL CHARACTERISTICS (PER LEG)
IRRM
Tstg
TJ
dv/dt
1.0
– 65 to +150
– 65 to +125
10,000
Amp
°C
°C
V/µs
Thermal Resistance — Junction to Case
— Junction to Ambient (1)
(1) When mounted using minimum recommended pad size on FR–4 board.
RθJC
RθJA
2.0 °C/W
50
Designer’s Data for “Worst Case” Conditions — The Designer’s Data Sheet permits the design of most circuits entirely from the information presented. SOA Limit
curves — representing boundaries on device characteristics — are given to facilitate “worst case” design.
Designer’s and SWITCHMODE are trademarks of Motorola, Inc.
Thermal Clad is a trademark of the Bergquist Company
Preferred devices are Motorola recommended choices for future use and best overall value.
Rev 1
©RMeoctotriofilea,rInDce. 1v9ic96e Data
1



MBRB2535CTL
MBRB2535CTL
ELECTRICAL CHARACTERISTICS (PER LEG)
Rating
Maximum Instantaneous Forward Voltage (2)
(iF = 25 Amps, TJ = 25°C)
(iF = 12.5 Amps, TJ = 125°C)
(iF = 12.5 Amps, TJ = 25°C)
Maximum Instantaneous Reverse Current (2)
(Rated dc Voltage, TJ = 125°C)
(Rated dc Voltage, TJ = 25°C)
(2) Pulse Test: Pulse Width = 300 µs, Duty Cycle 2.0%.
Symbol
vF
iR
Value
0.55
0.41
0.47
500
10
Unit
Volts
mA
50
20 TJ = 125°C
10
5
2 TJ = 25°C
1
0.5
0.2
0.1
0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0.8 0.9 10
vF, INSTANTANEOUS VOLTAGE (VOLTS)
Figure 1. Typical Forward Voltage, Per Leg
1000
TJ = 125°C
100
TJ = 100°C
10
1
TJ = 25°C
0.1
0 5 10 15 20 25 30 35
VR, REVERSE VOLTAGE (VOLTS)
Figure 2. Typical Reverse Current, Per Leg
40
TJ = 125°C
35
30
25 SINE WAVE
20 (RESISTIVE LOAD)
15
SQUARE
WAVE
DC
10
5
0
0 5 10 15 20 25 30 35
IF(AV), AVERAGE FORWARD CURRENT (AMPS)
Figure 3. Typical Forward Power Dissipation
40
32
28
24
20
16
12
8
4
0
85
(RATED Vr APPLIED)
RθJC = 2°C/W
SQUARE
DC
95 105 115
TC, CASE TEMPERATURE (°C)
Figure 4. Current Derating, Case
125
2 Rectifier Device Data




@ 2014 :: Datasheetspdf.com ::
Semiconductors datasheet search & download site (Privacy Policy & Contact)