MIC2525
Micrel
MIC2525
USB Power Control Switch Not Recommended for New Designs
Refer to MIC2025
General Description
...
MIC2525
Micrel
MIC2525
USB Power Control Switch Not Recommended for New Designs
Refer to MIC2025
General Description
The MIC2525 is an integrated high-side power switch, optimized for self-powered and bus-powered Universal Serial Bus (USB) applications. Few external components are necessary to satisfy USB requirements. The MIC2525 satisfies the following USB requirements: each switch channel supplies up to 500mA as required by USB downstream devices; the switch’s low on-resistance meets USB
voltage drop requirements; fault current is limited to typically 750mA, well below the UL 25VA safety requirements; and a flag output is available to indicate fault conditions to the local USB controller. Soft start eliminates the momentary
voltage drop on the upstream port that may occur when the switch is enabled in bus-powered applications. Additional features include thermal shutdown to prevent catastrophic switch failure from high-current loads, under
voltage lockout (UVLO) to ensure that the device remains off unless there is a valid input
voltage present, and 3.3V and 5V logic compatible enable inputs. The MIC2525 is a UL recognized component and is available in active-high and active-low versions in 8-pin DIP and SOIC packages.
Features
Compliant to USB specifications UL Recognized Component 3V to 5.5V input 500mA minimum continuous load current per port 140mΩ maximum on-resistance 1.25A maximum short circuit current limit Open-drain fault f...