MT7200
350mA LED driver with internal switch
DESCRIPTION
The MT7200 is a continuous mode inductive step-down converter, ...
MT7200
350mA LED driver with internal switch
DESCRIPTION
The MT7200 is a continuous mode inductive step-down converter, designed for driving single or multiple series connected LEDs efficiently from a
voltage source higher than the LED
voltage. The device operates from an input supply between 7~40V and provides an externally adjustable output current of up to 350mA. Depending upon supply
voltage and external components, this can provide up to 8 watts of output power. The MT7200 includes the output switch and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current. Output current can be adjusted above, or below the set value, by applying an external control signal to the 'ADJ' pin. The ADJ pin will accept either a DC
voltage or a PWM waveform. Depending upon the control frequency, this will provide either a continuous or a gated output current. The PWM filter components are contained within the chip. The PWM filter provides a soft-start feature by controlling the rise of input/output current. The soft-start time can be increased using an external capacitor from the ADJ pin to ground. Applying a
voltage of 0.2V or lower to the ADJ pin turns the output off and switches the device into a low current standby state. The device is assembled in a SOT23-5/SOT89-5 pin package.
FEATURES
Pass 4KV ESD test Simple low parts count 350mA output current Single pin on/off and brightness control using DC volt...