SN75130 QUADRUPLE LINE DRIVER
D Meets or Exceeds the Requirements of IBM
360/370 Input/Output Interface
Specification G...
SN75130 QUADRUPLE LINE DRIVER
D Meets or Exceeds the Requirements of IBM
360/370 Input/Output Interface
Specification GA22-6974-3
D Minimum Output
Voltage of 3.11 V
at IOH = – 59.3 mA
D Fault-Flag Circuit Output Signals Driver
Output Fault
D Fault-Detection Current-Limit Circuit
Minimizes Power Dissipation During a
Fault Condition
D Common Enable and Common Fault Flag D Designed to Be an Improved Replacement
for the MC3485
SLLS077B – FEBRUARY 1990 – REVISED MAY 1995
D OR N PACKAGE (TOP VIEW)
1Y 1W 1A
G 2A 2W 2Y GND
1 2 3 4 5 6 7 8
16 VCC 15 4Y 14 4W 13 4A 12 F 11 3A 10 3W 9 3Y
description
The SN75130 quadruple line driver is designed to meet the IBM 360/370 I/O specification GA22-6974-3. The output
voltage is 3.11 V minimum (at IOH = – 59.3 mA) over the recommended ranges of supply
voltage (4.5 V to 5.95 V) and temperature (0°C to 70°C). Driver outputs use a fault-detection current-limit circuit to allow high drive current but still minimize power dissipation when the output is shorted to ground. The SN75130 is compatible with standard TTL logic and supply
voltages.
Fault-flag circuitry is designed to sense and signal a line short on any Y line. Upon detecting an output fault condition, the fault-flag circuit forces the driver output into the off (low) state and signals a fault condition by causing the fault-flag output to go low.
The SN75130 can drive a 50-Ω load or a 90-Ω load as used in many I/O systems. Optimum performance can be achieved when the device is used wit...