TOSHIBA PHOTOCOUPLER IRLED & PHOTO-IC
TLX9378
TLX9378
HEV (Hybrid Electric Vehicle) and EV (Electric Vehicle) Applica...
TOSHIBA PHOTOCOUPLER IRLED & PHOTO-IC
TLX9378
TLX9378
HEV (Hybrid Electric Vehicle) and EV (Electric Vehicle) Applications
Unit: mm
The Toshiba TLX9378 consists of an infrared LED and integrated high gain, high-speed photodetector. The TLX9378 is housed in the SO6 package. The output stage is an open collector type.
The photodetector has an internal Faraday shield that provides a guaranteed common-mode transient immunity of 15 kV/μs. TLX9378 guarantees minimum and maximum of propagation delay time, switching speed dispersion, and high common mode transient immunity. Therefore TLX9378 is suitable for isolation interface between IPM (Intelligent Power Module) in motor control application.
Input current logic LOW output
: 5 mA (max)
Switching Speed
: 10 MBd (typ.)
Common mode transient immunity : 15 kV/μs (min)
Operating Temperature
: -40 to 125 °C
Isolation
voltage
: 3750 Vrms (min)
AEC-Q101 qualified
JEDEC
―
JEITA
―
TOSHIBA
11-4L1
Weight: 0.08 g (typ.)
Pin Configuration
1: ANODE 3: CATHODE 4: GND 5: VO (open collector) 6: VCC
Truth Table
Input H L
LED ON OFF
Output L H
Schematic
IF 1+
3-
ICC VCC
IO 6
VO 5
SHIELD
GND 4
A ceramic capacitor (0.1 μF) should be connected from pin 6 (VCC) to pin 4 (GND) to stabilize the operation of the high gain linear amplifier. Failure to provide the bypass may impair the switching property. The total lead length between capacitor and coupler should not exceed 1 cm.
© 2019 Toshiba Electronic Devices &...