INDUCTORS
June 2017
Inductors for Power Circuits
Wound Ferrite
VLF-M Series
VLF403212MT Type
VLF403212MT
Caution
May 18, 2017 Mar. 29, 2019 Sep. 30, 2019
INDUCTORS
REMINDERS FOR USING THESE PRODUCTS
Before using these products, be sure to request the delivery specifications.
SAFETY REMINDERS
Please pay sufficient attention to the warnings for safe designing when using these products.
(2/9)
REMINDERS
The storage period is less than 12 months. Be sure to follow the storage conditions (Temperat.
INDUCTORS
INDUCTORS
June 2017
Inductors for Power Circuits
Wound Ferrite
VLF-M Series
VLF403212MT Type
VLF403212MT
Caution
May 18, 2017 Mar. 29, 2019 Sep. 30, 2019
INDUCTORS
REMINDERS FOR USING THESE PRODUCTS
Before using these products, be sure to request the delivery specifications.
SAFETY REMINDERS
Please pay sufficient attention to the warnings for safe designing when using these products.
(2/9)
REMINDERS
The storage period is less than 12 months. Be sure to follow the storage conditions (Temperature: 5 to 40°C, Humidity: 10 to 75% RH or less). If the storage period elapses, the soldering of the terminal electrodes may deteriorate.
Do not use or store in locations where there are conditions such as gas corrosion (salt, acid, alkali, etc.).
Before soldering, be sure to preheat components. The preheating temperature should be set so that the temperature difference between the solder temperature and chip temperature does not exceed 150°C.
Soldering corrections after mounting should be within the range of the conditions determined in the specifications. If overheated, a short circuit, performance deterioration, or lifespan shortening may occur.
When embedding a printed circuit board where a chip is mounted to a set, be sure that residual stress is not given to the chip due to the overall distortion of the printed circuit board and partial distortion such as at screw tightening portions.
Self heating (temperature increase) occurs when the power is turned ON, so the tolerance should .