DATASHEET
X9015
Low Noise, Low Power, Volatile Single Digitally Controlled (XDCP™) Potentiometer
FN8157 Rev 6.00 Augus...
DATASHEET
X9015
Low Noise, Low Power, Volatile Single Digitally Controlled (XDCP™) Potentiometer
FN8157 Rev 6.00 August 14, 2015
The Intersil X9015 is a 32 tap potentiometer that is volatile. The device consists of a string of 31 resistors that can be programmed to connect the RW/VW wiper output with any of the nodes between the connecting resistors. The connection point of the wiper is determined by information communicated to the device on the 3-wire port. The 3-wire port changes the tap position by a falling edge on the increment pin. The direction the wiper moves is determined by the state of the up/down pin. The wiper position at power up is Tap #15.
The X9015 can be used in a wide variety of applications that require a digitally controlled variable resistor to set analog values.
Features
32 taps Three-wire up/down serial interface VCC = 2.7V–5V Operating ICC = 50µA max. Standby current = 1µA max. RTOTAL = 10k, 50k Packages 8 Ld SOIC, 8 Ld MSOP Pb-free plus anneal available (RoHS compliant)
Pinout
SOIC/MSOP
INC
U/D RH/VH
VSS
1 2
X9015 3 4
8 7 6 5
VCC
CS RL/VL RW/VW
Block Diagram
VCC (Supply
Voltage)
Up/Down (U/D)
Increment (INC)
Device Select (CS)
Control
VSS (Ground) General
U/D INC CS
RH/VH RW/VW RL/VL
VCC VSS
5-Bit Up/Down Counter
Control Circuitry
31
30
29
One 28 of
Thirty Two Decoder
2
1
0
Transfer Gates
Resistor Array
Detailed
RH/VH
RL/VL RW/VW
FN8157 Rev 6.00 August 14, 2015
Page 1 of 12
X9015
Ordering Information
PART ...