Stereo CODEC. WM8961 Datasheet

WM8961 CODEC. Datasheet pdf. Equivalent

WM8961 Datasheet
Recommendation WM8961 Datasheet
Part WM8961
Description Ultra-Low Power Stereo CODEC
Feature WM8961; w WM8961 Ultra-Low Power Stereo CODEC with 1W Stereo Class D Speaker Drivers and Ground Referenced.
Manufacture Wolfson Microelectronics
Datasheet
Download WM8961 Datasheet




Wolfson Microelectronics WM8961
w
WM8961
Ultra-Low Power Stereo CODEC with 1W Stereo Class D
Speaker Drivers and Ground Referenced Headphone Drivers
DESCRIPTION
FEATURES
The WM8961 is a low power, high quality stereo CODEC
designed for portable digital audio applications.
An integrated charge pump provides a ground referenced output
which removes the need for DC-blocking capacitors on the
output, and uses the Wolfson ‘Class-W’ amplifier techniques -
incorporating an innovative dual-mode charge pump architecture
- to optimise efficiency and power consumption during playback.
A DC Servo is used to reduce DC ground offsets. This improves
power consumption and minimises pops and clicks.
Stereo class D speaker drivers provide 1W per channel into 8Ω
loads with a 5V supply. Low leakage, excellent PSRR and
pop/click suppression mechanisms also allow direct battery
connection to the speaker supply. Flexible speaker boost
settings allow speaker output power to be maximised while
minimising other analogue supply currents.
Control sequences for audio path setup can be pre-loaded
and executed by an integrated sequencer to reduce
software driver development and eliminate pops and clicks
via Wolfson’s SilentSwitch™ technology.
Flexible input configuration : a stereo input or two mono inputs
on Lch or Rch ADC, with a complete microphone interface.
External component requirements are drastically reduced as no
separate microphone, speaker or headphone amplifiers are
required. Advanced on-chip digital signal processing performs
automatic level control for the microphone or line input.
Stereo 24-bit sigma-delta ADCs and DACs are used with low
power over-sampling digital interpolation and decimation filters
and a flexible digital audio interface.
The WM8961 operates at analogue supply voltages down to
1.71V, although the digital supplies can operate at voltages
down to 1.62V to save power. The speaker supply can operate
at up to 5.5V, providing 1W per channel into 8Ω loads. Unused
functions can be disabled using software control to save power.
The WM8961 is supplied in a very small and thin 5x5mm QFN
package, ideal for use in hand-held and portable systems.
DAC SNR 98dB (‘A’ weighted), THD -83dB at 48kHz, 1.8V
ADC SNR 88dB (‘A’ weighted), THD -75dB at 48kHz, 1.8V
Stereo Class D Speaker Driver
- 1W per channel into 8Ω BTL speakers.
- Flexible internal switching clock
Wolfson ‘Class-W’ ultra-low power headphone Driver
- Up to 22mW per channel output power at -80dB
THD+N into 16Ω at 1.8V
- Ground Referenced
- Low offset (+/- 1.5mV)
- Pop and click suppression
- Control sequencer for pop-minimised start-up and
shut-down
- Single register write for default start-up sequence
Microphone Interface
- Single ended stereo input
- Integrated low noise MICBIAS
- Programmable ALC / Limiter and Noise Gate
Low Power Consumption
- 6.99mW headphone playback (1.8V supplies, Low
Power mode)
Low Supply Voltages
- Analogue 1.71V to 2.0V (Speaker supply up to 5.5V)
- Charge pump 1.71V to 2.0V
- MIC bias amp supply 1.71V to 3.6V
- Digital 1.62V to 2.0V
2-wire serial control interface including read-back
Sample rates: 8, 11.025, 12, 16, 22.05, 24, 32, 44.1, 48
5x5x0.9mm 32 pin QFN package
APPLICATIONS
Games consoles
Portable media / DVD players
Mobile multimedia
WOLFSON MICROELECTRONICS plc
To receive regular email updates, sign up at http://www.wolfsonmicro.com/enews
Pre-Production, August 2009, Rev 3.1
Copyright ©2009 Wolfson Microelectronics plc



Wolfson Microelectronics WM8961
Pre-Production
BLOCK DIAGRAM
WM8961
w
PP, August 2009, Rev 3.1
2



Wolfson Microelectronics WM8961
WM8961
Pre-Production
TABLE OF CONTENTS
BLOCK DIAGRAM .................................................................................................2
PIN CONFIGURATION...........................................................................................5
ORDERING INFORMATION ..................................................................................5
PIN DESCRIPTION ................................................................................................6
ABSOLUTE MAXIMUM RATINGS.........................................................................7
ABSOLUTE MAXIMUM RATINGS.........................................................................7
RECOMMENDED OPERATING CONDITIONS .....................................................7
ELECTRICAL CHARACTERISTICS ......................................................................8
TYPICAL POWER CONSUMPTION ....................................................................12
COMMON TEST CONDITIONS................................................................................... 12
MEASUREMENTS ...................................................................................................... 12
SIGNAL TIMING REQUIREMENTS .....................................................................14
SYSTEM CLOCK TIMING ........................................................................................... 14
AUDIO INTERFACE TIMING – MASTER MODE......................................................... 14
AUDIO INTERFACE TIMING – SLAVE MODE............................................................ 15
CONTROL INTERFACE TIMING................................................................................. 16
INTERNAL POWER ON RESET CIRCUIT .................................................................. 17
DEVICE DESCRIPTION .......................................................................................19
INTRODUCTION ......................................................................................................... 19
CONTROL INTERFACE .............................................................................................. 20
INPUT SIGNAL PATH ................................................................................................. 22
ANALOGUE TO DIGITAL CONVERTER (ADC) .......................................................... 26
AUTOMATIC LEVEL CONTROL (ALC) ....................................................................... 31
OUTPUT SIGNAL PATH ............................................................................................. 35
ANALOGUE OUTPUTS............................................................................................... 41
HEADPHONE PLAYBACK MODES ............................................................................ 46
INPUT AND OUTPUT VOLUME UPDATES ................................................................ 51
DC SERVO.................................................................................................................. 53
CHARGE PUMP.......................................................................................................... 56
DIGITAL AUDIO INTERFACE ..................................................................................... 58
CONTROL WRITE SEQUENCER ............................................................................... 65
CLOCKING AND SAMPLE RATES ............................................................................. 71
VMID GENERATOR .................................................................................................... 78
THERMAL SHUTDOWN AND STATUS ...................................................................... 79
CHIP DEVICE ID ......................................................................................................... 80
CHIP SOFTWARE RESET .......................................................................................... 80
REGISTER MAP ..................................................................................................81
REGISTER BITS BY ADDRESS.................................................................................. 83
DIGITAL FILTER CHARACTERISTICS.............................................................101
DAC FILTER RESPONSES....................................................................................... 102
ADC FILTER RESPONSES....................................................................................... 104
DE-EMPHASIS FILTER RESPONSES...................................................................... 106
APPLICATIONS INFORMATION .......................................................................107
RECOMMENDED EXTERNAL COMPONENTS ........................................................ 107
SPEAKER SELECTION............................................................................................. 108
PCB LAYOUT CONSIDERATIONS ........................................................................... 109
EXAMPLE CONFIGURATIONS................................................................................. 110
w
PP, August 2009, Rev 3.1
3







@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site (Privacy Policy & Contact)