40V 1.5A BUCK LED DRIVER
AL8860
40V 1.5A BUCK LED DRIVER
Description
The AL8860 is a hysteresis mode DC-DC step-down converter, designed for dri...
Description
AL8860
40V 1.5A BUCK LED DRIVER
Description
The AL8860 is a hysteresis mode DC-DC step-down converter, designed for driving single or multiple series connected LEDs efficiently from a voltage source higher than the LED voltage. The device can operate from an input supply between 4.5V and 40V and provide an externally adjustable output current up to 1A for TSOT25 package and 1.5A for MSOP-8EP package. Depending upon supply voltage and external components, this converter can provide up to 40 watts output power.
Pin Assignments
(Top View)
The AL8860 integrates the power switch and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current.
TSOT25 (Top View)
Dimming can be realized by applying an external control signal to the
CTRL pin. The CTRL pin will accept either a DC voltage signal or a
PWM signal.
EP
The soft-start time can be adjusted by an external capacitor from the CTRL pin to ground. Applying a voltage of 0.2V or lower to the CTRL pin can turn off the output and make the device enter standby state with low current consumption.
MSOP-8EP
Features
Low BOM Counts Wide Input Voltage Range: 4.5V to 40V Output Current up to 1.5A Internal 40V NDMOS Switch Typical 5% Output Current Accuracy Single Pin for On/Off and Brightness Control by DC Voltage or
PWM Signal Recommended Analog Dimming Range: 5% to 100% Soft-Start High Efficiency (Up to 97%) LED Short Protection Inherent Open-Circuit...
Similar Datasheet