USB 2.0 to 10/100 Ethernet Controller
LAN89530
USB 2.0 to 10/100 Ethernet Controller for Automotive Applications
Highlights
• Single Chip Hi-Speed USB 2.0 t...
Description
LAN89530
USB 2.0 to 10/100 Ethernet Controller for Automotive Applications
Highlights
Single Chip Hi-Speed USB 2.0 to 10/100 Ethernet Controller
Integrated 10/100 Ethernet MAC with Full-Duplex Support
Integrated 10/100 Ethernet PHY with HP AutoMDIX Support
Integrated USB 2.0 Hi-Speed Device Controller
Integrated USB 2.0 Hi-Speed PHY
Implements Reduced Power Operating Modes
Target Applications
Diagnostic Interface (for Dealership Service Bay)
Fast Software Download Interface (e.g., OBD Connector)
Gateway Service Interface (Dealership, Aftermarket Repair Shop)
In-vehicle Engineering Development Interface
Vehicle Manufacturing Test Interface (Production Plant Assembly Line)
Legislated Inspections (Emissions Check, Safety Inspections)
Key Features
USB Device Controller
- Fully compliant with Hi-Speed Universal Serial Bus Specification, revision 2.0
- Supports HS (480 Mbps) and FS (12 Mbps) modes
- Four Endpoints supported - Supports vendor specific commands - Integrated USB 2.0 PHY - Remote wakeup supported
High-Performance 10/100 Ethernet Controller
- Fully compliant with IEEE 802.3/802.3u - Integrated Ethernet MAC and PHY - 10BASE-T and 100BASE-TX support - Full- and half-duplex support - Full- and half-duplex flow control - Preamble generation and removal - Automatic 32-bit CRC generation and checking - Automatic payload padding and pad removal - Loop-back modes - TCP/UDP/IP/ICMP checksum offload support - Flexible address filtering modes
- One 48...
Similar Datasheet