Don’t Drop Water on LCD!
Note that the presence of
waterdrops or dew in the
LCD panel may deteriorate
the polarizer or corrade
Precaution in Soldering LCD Module
Basic instructions: Solder I/O terminals only.
Use soldering iron without leakage.
(1)Soldering condition to I/O terminals
Temperature at tip of the iron: 280±10℃
Soldering time: 3~4 sec.
Type of solder: Eutectic solder (containing colophony-flux)
*Please do not use flux because it may soak into LCD Module or contaminate it.
*It is preferable to peel off protective film on display surface after soldering I/O
terminals is finished.
(2)Remove connector or cable
*When you remove connector or cable soldered to I/O terminals, please confirm
that solder is fully melted. If you remove by force, electrodes at I/O terminals may
be damaged(or stripped off).
*It is recommended to use solder suction machine.
If it is necessary to store LCD modules for a long time, please comply with the
If storage condition is not satisfactory, display(especially polarizer) may be deteriorated
or soldering I/O terminals may become difficult(some oxide is generated at I/O
1.Store as delivered by Optrex
2.If you store as unpacked,put in anti-static bag,seal its opening and store where it is
not subjected to direct sunshine nor fluorescent lamp.
3.Store at temperature 0 to +35℃ and at low humidity.Please refer to our specification
sheets for storage temperature range and humidity condition.
Please use power supply with built-in surge protection circuit.
Na-3323, Chungang Circulation Complex, #1258, Guro Bon-Dong, Guro-Gu, Seoul, 152-721, Korea.
Tel ; 82-2-2612-4767 , Fax ; 82-2-6679-5767
Free Datasheet http://www.datasheet4u.com/