3.2 Inspection Specification
Inspection Standard：MIL-STD-105E Table Normal Inspection Single Sampling Level Ⅱ。
IQC Defect Level：Major Defect AQL 0.4; Minor Defect AQL 1.5。
FQC Defect Level：100% Inspection。
OUT Going Defect Level：Sampling。
The part number
The quantity is inconsistent with work order of
The display lacks of some patterns.
The size of missing dot, A is＞1/2 Dot size
A=( L + W )÷2 There is no function.
Output data is error
Material is different with work order of production
LCD is assembled in inverse direction
Bezel is assembled in inverse direction
Shadow is within LCD viewing area + 0.5 mm
Appearance of The diameter of dirty particle, A is＞0.4 mm
Dirty particle length is ＞3.0mm, and 0.01mm＜width
A=( L + W )÷2 ≦0.05mm
4 Display is without protective film
Conductive rubber is over bezel 1mm
scratch、bubble ) Polarizer exceeds over viewing area of LCD
Area of bubble in polarizer, A＞1.0mm, the number of
bubble is ＞1 piece.
0.4mm＜Area of bubble in polarizer, A＜1.0mm, the
number of bubble is ＞4 pieces.
Burned area or wrong part number is on PCB
The symbol, character, and mark of PCB are
The stripped solder mask , A is＞1.0mm
0.3mm＜stripped solder mask or visible circuit, A ＜
A=( L + W )÷2
1.0mm, and the number is ≧4 pieces
There is particle between the circuits in solder mask
The circuit is peeled off or cracked
There is any circuits risen or exposed.
0.2mm＜Area of solder ball, A is ≦0.4mm
The number of solder ball is ≧3 pieces
The magnitude of solder ball, A is ＞0.4mm.
PC1601LRS-LWA-B-Q Rev.0 (DK)