40V 1.5A BUCK LED DRIVER
AL8861
40V 1.5A BUCK LED DRIVER
Description
The DIODESTM AL8861 is a hysteresis-mode DC-DC step-down converter, designe...
Description
AL8861
40V 1.5A BUCK LED DRIVER
Description
The DIODESTM AL8861 is a hysteresis-mode DC-DC step-down converter, designed for driving single or multiple series connected LEDs efficiently from a voltage source higher than the LED voltage. The device can operate from an input supply between 4.5V and 40V and provide an externally adjustable output current up to 1A for TSOT25 package and 1.5A for SOT89-5 and MSOP-8EP packages. Depending upon supply voltage and external components, this converter can provide up to 40W of output power.
The AL8861 integrates the power switch and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current.
Dimming can be realized by applying an external control signal to the VSET pin. The VSET pin will accept either a DC voltage signal or a PWM signal.
Pin Assignments
(Top View)
LX 1
5 VIN
GND 2
VSET 3
4 ISENSE TSOT25
LX 1
(Top View)
5 VIN
The soft-start time can be adjusted by an external capacitor from the VSET pin to Ground. Applying a voltage of 0.2V or lower to the VSET pin can turn off the output and make the device enter into standby state with low current consumption.
Features
Low BOM Counts Wide Input Voltage Range: 4.5V to 40V Output Current up to 1.5A Internal 40V NDMOS Switch Typical 5% Output Current Accuracy Single Pin for On/Off and Brightness Control by DC Voltage or
PWM Signal Recommended Analog Dimming Range: 5% to 100% Soft-Start High Efficiency ...
Similar Datasheet