Dual 4-channel analog multiplexer/demultiplexer
74HC4852; 74HCT4852
Dual 4-channel analog multiplexer/demultiplexer with
injection-current effect control
Rev. 4 — 28...
Description
74HC4852; 74HCT4852
Dual 4-channel analog multiplexer/demultiplexer with
injection-current effect control
Rev. 4 — 28 April 2020
Product data sheet
1. General description
The 74HC4852; 74HCT4852 are dual single-pole quad-throw analog switches (SP4T) suitable for use in analog or digital 4:1 multiplexer/demultiplexer applications. Each switch features four independent inputs/outputs (nY0, nY1, nY2 and nY3) and a common input/output (nZ). A digital enable input (E) and two digital select inputs (S0 & S1) are common to both switches. When E is HIGH, the switches are turned off. The device features injection-current effect control. This allows signals at disabled analog input channels to exceed the supply voltage without affecting the signal of the enabled analog channel, eliminating the need for external diode/resistor networks typically used to keep the analog channel signals within the supply-voltage range. Inputs include clamp diodes. This enables the use of current limiting resistors to interface inputs to voltages in excess of VCC.
2. Features
Injection-current cross coupling < 1 mV/mA Wide supply voltage range from 2.0 V to 6.0 V for 74HC4852 ESD protection:
HBM JESD22-A114E exceeds 2000 V CDM JESD22-C101C exceeds 1000 V Latch-up performance exceeds 100 mA per JESD 78 Class II level A Low ON-state resistance: 400 Ω (typical) at VCC = 2.0 V 215 Ω (typical) at VCC = 3.0 V 120 Ω (typical) at VCC = 3.3 V 76 Ω (typical) at VCC = 4.5 V 59 Ω (typica...
Similar Datasheet