QUADRUPLE 2-LINE TO 1-LINE DATA SELECTOR/MULTIPLEXER
74AC11257
QUADRUPLE 2-LINE TO 1-LINE DATA SELECTOR/MULTIPLEXER
WITH 3-STATE OUTPUTS
SCAS049C − MARCH 1989 − REVISED MAY ...
Description
74AC11257
QUADRUPLE 2-LINE TO 1-LINE DATA SELECTOR/MULTIPLEXER
WITH 3-STATE OUTPUTS
SCAS049C − MARCH 1989 − REVISED MAY 2004
D 3-State Outputs Interface Directly With
System Bus
D Flow-Through Architecture Optimizes
PCB Layout
D Center-Pin VCC and GND Configurations
Minimize High-Speed Switching Noise
D 500-mA Typical Latch-Up Immunity at
125°C
D Provides Bus Interface From Multiple
Sources in High-Performance Systems
description/ordering information
DB, DW, N, OR PW PACKAGE (TOP VIEW)
A/B 1Y 2Y GND GND GND GND 3Y 4Y OE
1 2 3 4 5 6 7 8 9 10
20 1A 19 1B 18 2A 17 2B 16 VCC 15 VCC 14 3A 13 3B 12 4A 11 4B
This device is designed to multiplex signals from 4-bit data sources to four output data lines in bus-organized systems. The 3-state outputs do not load the data lines when the output-enable (OE) input is at a high logic level.
To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
ORDERING INFORMATION
TA
PACKAGE†
ORDERABLE PART NUMBER
TOP-SIDE MARKING
PDIP − N
Tube
74AC11257N
74AC11257N
−40°C to 85°C
SOIC − DW SSOP − DB
Tube Tape and reel Tape and reel
74AC11257DW 74AC11257DWR 74AC11257DBR
AC11257 AE257
TSSOP − PW
Tube Tape and reel
74AC11257PW 74AC11257PWR
AE257
† Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are
available at www.ti.com/sc...
Similar Datasheet