18-BIT REGISTERED TRANSCEIVERS
54ACT16475, 74ACT16475
18-BIT REGISTERED TRANSCEIVERS
WITH 3-STATE OUTPUTS
SCAS198A – OCTOBER 1990 – REVISED APRIL 1996
...
Description
54ACT16475, 74ACT16475
18-BIT REGISTERED TRANSCEIVERS
WITH 3-STATE OUTPUTS
SCAS198A – OCTOBER 1990 – REVISED APRIL 1996
D Members of the Texas Instruments
Widebus™ Family
D Inputs Are TTL-Voltage Compatible D 3-State Inverting Outputs D Flow-Through Architecture Optimizes
PCB Layout
D Distributed VCC and GND Pin Configuration
Minimizes High-Speed Switching Noise
D EPIC™ (Enhanced-Performance Implanted
CMOS) 1-µm Process
D 500-mA Typical Latch-Up Immunity at
125°C
D Packaged in Plastic 300-mil Shrink
Small-Outline (DL) Packages Using 25-mil Center-to-Center Pin Spacings and 380-mil Fine-Pitch Ceramic Flat (WD) Packages Using 25-mil Center-to-Center Pin Spacings
description
The ’ACT16475 are 18-bit registered transceivers that contain two sets of D-type flip-flops for temporary storage of data flowing in either direction. They can be used as two 9-bit transceivers or one 18-bit transceiver. Separate clock (CLKAB and CLKBA) and output-enable (OEAB or OEBA) inputs are provided for each register to permit independent control in either direction of data flow.
Data at the A inputs meeting the setup time requirements is transferred to the B outputs on the positive-going edge of CLKAB. With OEAB low, the 3-state B outputs are enabled and reflect the inverted A data. Data flow from B to A is similar but requires the use of the CLKBA and OEBA inputs.
54ACT16475 . . . WD PACKAGE 74ACT16475 . . . DL PACKAGE
(TOP VIEW)
1OEAB 1CLKAB
1A1 GND 1A2 1A3 VCC 1A4 1A5 1A6 GND 1A7 1A8 1A9 2A1 2A2...
Similar Datasheet