TGHDV100RJE

TGHD Series Chassis Mounting Non-inductive High Power Resistors F e at u r e s #187 Quick connect tabs or fly wire leads Flat type, 100W high power resistor Air-cooled heat sink or water-cooling required. Higher density packing, vibration-proof, insulation withstand voltage and perfect heat dissipation possible. TGHDX with wire leads follows the popular SOT-227 land pattern. A p p l i c at i o n s Harmonic filter Gate resistor Snubber resistors Dumping resistor for Surge protection automotive electronics Breeder resistor Power supplies Dummy load High frequency amplifiers c h a r a c t e r i st i c s Rated Power Heat Resistance Resistance Range Nominal Resistance TCR Tolerance Operation Temp. Max. Applied Voltage Withstanding Voltage Torque Weight Insulation Resistance 100W at flange temperature -55 to +100°C (wire leads) or -55 to +25°C (quick connect) 0.5°C/W (wire leads) or 1.1°C/W (quick connect) from resistor to flange 0.1Ω to 51kΩ; lowest 0.1 ohm is available E24+ Modified E24, additionally, 2.0 and 5.0 ±100 ppm/K (A) For -55 to +155°C ±5% (J) -55 to +155°C at flange element surface E = √P·R or 1000V 5000 VAC 60 seconds, leak current below 0.5mA Mounting 1.6Nm max, 1.0Nm recommend 14g Over 1000MΩ between terminals and flange Test Load Life Humidity Temperature Cycle Vibration Flammability Procedure Continuous power 1000 hours 60°C, 90 to 95%RH, DC0.1W, 1000 hours -55°C, 30 min.,+155°C 30min., 5 cycles IEC60068-2-6, displacement 0....