Chassis Mounting Non-inductive High Power Resistors
TGHD Series
Chassis Mounting Non-inductive High Power Resistors
F e at u r e s
• #187 Quick connect tabs or fly wire lea...
Description
TGHD Series
Chassis Mounting Non-inductive High Power Resistors
F e at u r e s
#187 Quick connect tabs or fly wire leads Flat type, 100W high power resistor Air-cooled heat sink or water-cooling required. Higher density packing, vibration-proof, insulation withstand voltage and perfect heat dissipation possible. TGHDX with wire leads follows the popular SOT-227 land pattern.
A p p l i c at i o n s
Harmonic filter Gate resistor
Snubber resistors Dumping resistor for
Surge protection automotive electronics
Breeder resistor Power supplies
Dummy load
High frequency amplifiers
c h a r a c t e r i st i c s
Rated Power
Heat Resistance Resistance Range Nominal Resistance
TCR Tolerance Operation Temp. Max. Applied Voltage Withstanding Voltage
Torque Weight Insulation Resistance
100W at flange temperature -55 to +100°C (wire leads) or -55 to +25°C (quick connect) 0.5°C/W (wire leads) or 1.1°C/W (quick connect) from resistor to flange 0.1Ω to 51kΩ; lowest 0.1 ohm is available E24+ Modified E24, additionally, 2.0 and 5.0 ±100 ppm/K (A) For -55 to +155°C ±5% (J) -55 to +155°C at flange element surface E = √P·R or 1000V 5000 VAC 60 seconds, leak current below 0.5mA Mounting 1.6Nm max, 1.0Nm recommend 14g Over 1000MΩ between terminals and flange
Test Load Life Humidity Temperature Cycle Vibration
Flammability
Procedure
Continuous power 1000 hours 60°C, 90 to 95%RH, DC0.1W, 1000 hours -55°C, 30 min.,+155°C 30min., 5 cycles IEC60068-2-6, displacement 0....
Similar Datasheet