Flash MCU. C8051F360 Datasheet

C8051F360 MCU. Datasheet pdf. Equivalent

C8051F360 Datasheet
Recommendation C8051F360 Datasheet
Part C8051F360
Description Mixed Signal ISP Flash MCU
Feature C8051F360; C8051F360/1/2/3/4/5/6/7/8/9 Mixed Signal ISP Flash MCU Family Analog Peripherals - 10-Bit ADC (‘F3.
Manufacture Silicon Laboratories
Datasheet
Download C8051F360 Datasheet





Silicon Laboratories C8051F360
C8051F360/1/2/3/4/5/6/7/8/9
Mixed Signal ISP Flash MCU Family
Analog Peripherals
- 10-Bit ADC (‘F360/1/2/6/7/8/9 only)
Up to 200 ksps
Up to 21 external single-ended or differential inputs
VREF from internal VREF, external pin or VDD
Internal or external start of conversion source
Built-in temperature sensor
- 10-Bit Current Output DAC
(‘F360/1/2/6/7/8/9 only)
- Two Comparators
Programmable hysteresis and response time
Configurable as interrupt or reset source
Low current (0.4 µA)
- Brown-out detector and POR Circuitry
On-Chip Debug
- On-chip debug circuitry facilitates full speed, non-
intrusive in-system debug (no emulator required)
- Provides breakpoints, single stepping,
inspect/modify memory and registers
- Superior performance to emulation systems using
ICE-chips, target pods, and sockets
- Low cost, complete development kit
Supply Voltage
- Range: 2.7–3.6 V (50 MIPS) 3.0–3.6 V (100 MIPS)
- Power saving suspend and shutdown modes
High Speed 8051 µC Core
- Pipelined instruction architecture; executes 70% of
instructions in 1 or 2 system clocks
- 100 MIPS or 50 MIPS throughput with on-chip PLL
- Expanded interrupt handler
- 2-cycle 16 x 16 MAC engine
Memory
- 1280 bytes internal data RAM (256 + 1024)
- 32 kB (‘F360/1/2/3/4/5/6/7) or 16 kB (‘F368/9) Flash;
In-system programmable in 1024-byte Sectors—
1024 bytes are reserved in the 32 kB devices
Digital Peripherals
- up to 39 Port I/O; All 5 V tolerant with high sink cur-
rent
- Hardware enhanced UART, SMBus™, and
enhanced SPI™ serial ports
- Four general purpose 16-bit counter/timers
- 16-Bit programmable counter array (PCA) with six
capture/compare modules
- Real time clock mode using PCA or timer and exter-
nal clock source
- External Memory Interface (EMIF)
Clock Sources
- Two internal oscillators:
24.5 MHz with ±2% accuracy supports crystal-less
UART operation
80/40/20/10 kHz low frequency, low power
- Flexible PLL technology
- External oscillator: Crystal, RC, C, or clock
(1 or 2 pin modes)
- Can switch between clock sources on-the-fly; useful
in power saving modes
Packages
- 48-pin TQFP (C8051F360/3)
- 32-pin LQFP (C8051F361/4/6/8)
- 28-pin QFN (C8051F362/5/7/9)
Temperature Range: –40 to +85 °C
ANALOG
PERIPHERALS
VOLTAGE
+
+
COMPARATORS
-
-
A 10-bit
M
U
200 ksps
X ADC
‘F360/1/2/6/7/8/9 only
TEMP
SENSOR
10-bit
Current
DAC
DIGITAL I/O
UART
SMBus
Port 0
SPI
PCA
Port 1
Timer 0
Timer 1
Port 2
Timer 2
Timer 3
Port 3
Port 3
48-pin only
Port 4
HIGH-SPEED CONTROLLER CORE
WDT
16 x 16
MAC
8051 CPU
(100 or 50 MIPS)
1024 B
SRAM
POR
FLEXIBLE
DEBUG Internal Oscillator/ 32/16 kB
INTERRUPTS CIRCUITRY
LFO/PLL
ISP FLASH
Rev. 1.1 5/15
Copyright © 2015 by Silicon Laboratories
C8051F36x



Silicon Laboratories C8051F360
C8051F360/1/2/3/4/5/6/7/8/9
2 Rev. 1.1



Silicon Laboratories C8051F360
C8051F360/1/2/3/4/5/6/7/8/9
Table of Contents
1. System Overview.................................................................................................... 18
1.1. CIP-51™ Microcontroller Core.......................................................................... 22
1.1.1. Fully 8051 Compatible.............................................................................. 22
1.1.2. Improved Throughput ............................................................................... 22
1.1.3. Additional Features .................................................................................. 22
1.2. On-Chip Memory............................................................................................... 23
1.3. On-Chip Debug Circuitry................................................................................... 24
1.4. Programmable Digital I/O and Crossbar ........................................................... 25
1.5. Serial Ports ....................................................................................................... 26
1.6. Programmable Counter Array ........................................................................... 26
1.7. 10-Bit Analog to Digital Converter..................................................................... 27
1.8. Comparators ..................................................................................................... 28
1.9. 10-bit Current Output DAC................................................................................ 30
2. Absolute Maximum Ratings .................................................................................. 32
3. Global Electrical Characteristics .......................................................................... 33
4. Pinout and Package Definitions............................................................................ 36
5. 10-Bit ADC (ADC0, C8051F360/1/2/6/7/8/9)........................................................... 47
5.1. Analog Multiplexer ............................................................................................ 48
5.2. Temperature Sensor ......................................................................................... 49
5.3. Modes of Operation .......................................................................................... 51
5.3.1. Starting a Conversion............................................................................... 51
5.3.2. Tracking Modes........................................................................................ 52
5.3.3. Settling Time Requirements ..................................................................... 53
5.4. Programmable Window Detector ...................................................................... 57
5.4.1. Window Detector In Single-Ended Mode ................................................. 60
5.4.2. Window Detector In Differential Mode...................................................... 61
6. 10-Bit Current Mode DAC (IDA0, C8051F360/1/2/6/7/8/9) .................................... 63
6.1. IDA0 Output Scheduling ................................................................................... 63
6.1.1. Update Output On-Demand ..................................................................... 63
6.1.2. Update Output Based on Timer Overflow ................................................ 64
6.1.3. Update Output Based on CNVSTR Edge................................................. 64
6.2. IDAC Output Mapping....................................................................................... 64
7. Voltage Reference (C8051F360/1/2/6/7/8/9) .......................................................... 67
8. Comparators ........................................................................................................... 70
9. CIP-51 Microcontroller .......................................................................................... 80
9.1. Performance ..................................................................................................... 80
9.2. Programming and Debugging Support ............................................................. 81
9.3. Instruction Set ................................................................................................... 82
9.3.1. Instruction and CPU Timing ..................................................................... 82
9.3.2. MOVX Instruction and Program Memory ................................................. 82
9.4. Memory Organization........................................................................................ 86
9.4.1. Program Memory...................................................................................... 86
9.4.2. Data Memory............................................................................................ 87
Rev. 1.1
3





@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site (Privacy Policy & Contact)