TRF1015 DOWNCONVERTER Datasheet

TRF1015 Datasheet PDF, Equivalent


Part Number

TRF1015

Description

RF DOWNCONVERTER

Manufacture

etcTI

Total Page 21 Pages
Datasheet
Download TRF1015 Datasheet


TRF1015
TRF1015
RF DOWNCONVERTER
D Low-Noise Amplifier (LNA), Radio
Frequency (RF) Mixer, and
Voltage-Controlled Oscillator (VCO)
D Improved Compression Mode
D Conversion From RF to Intermediate
Frequency (IF) on a Single Chip
D Suitable for Portable 900-MHz Cellular and
Cordless Telephones
D Low-Current Consumption Mode
D 20-Pin Plastic Shrink Small Outline (SSOP)
Package
D Application-Selectable Internal or External
Oscillator
PD1
PD2
AUX_LO–
AUX_LO+
OSC2
VCO_GND
OSC1
VCO_VCC
VCO_BYP
LNA_GND
SLWS021D– JUNE 1996 – REVISED JULY 1998
DB PACKAGE
(TOP VIEW)
1 20 MIX_OUT–
2 19 MIX_OUT+
3 18 MIX_IN
4 17 MIX_GND
5 16 LNA_GND
6 15 LNA_IN
7 14 LNA_VCC
8 13 LNA_OUT
9 12 LNA_GND
10 11 LNA_GND
description
The Texas Instruments (TI) TRF1015 is a single-chip RF downconverter suitable for 900-MHz receiver
applications. It combines a low-noise amplifier (LNA), a buffered voltage-controlled oscillator (VCO), and an RF
mixer into a 20-pin SSOP package requiring very few external components.
Minimal power consumption can be further reduced by placing the required modules into operate mode and the
remaining modules into standby mode.
Three modes of operation are provided for both the LNA and the mixer: standby, low current, and improved
compression. The improved compression mode is suitable for applications that require full duplex capability.
The improved compression mode is suitable for maintaining receiver sensitivity in the presence of large
interfering signals and provides a low bit-error rate (BER) in digital modulation systems. The three modes of
operation are selectable in accordance with the presence of a high or low signal on PD1 and PD2, as shown
in Table 1.
Table 1. Mode Control
MODE
Standby
Low current
Improved compression
PD1 PD2
LL
HH
LH
The LNA has a gain of 13 dB and a noise figure of 2.2 dB. LNA input and output characteristic impedances are
50 . The single balanced RF mixer has a gain of 9 dB with a single-sideband (SSB) noise figure of 10 dB. The
VCO has a typical tuning range of 25 MHz using an external varactor and resonator. The VCO gain and tuning
range can be adjusted to meet the phase-locked loop (PLL) design requirement, with an external shunt and
feedback capacitors in series with the resonator. A buffered output of the VCO provides phase locking capability
and can be configured for single-ended or differential operation.
The TRF1015 is offered in the 20-pin SSOP (DB) package and is characterized for operation from – 40°C
to 85°C free-air temperature.
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
TI is a trademark of Texas Instruments Incorporated.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
Copyright © 1998, Texas Instruments Incorporated
POST OFFICE BOX 655303 DALLAS, TEXAS 75265
1

TRF1015
TRF1015
RF DOWNCONVERTER
SLWS021D– JUNE 1996 – REVISED JULY 1998
functional block diagram
PD1 1
PD2 2
VCO_GND 6
OSC2 5
OSC1 7
VCO_BYP 9
LNA_IN 15
Power Down
Logic
Power-Down Signal
To On-Board Circuits
Buffer
Amp
Buffer
Amp
20
19
18
17
3
4
8
10, 11, 12, 16
MIX_OUT–
MIX_OUT+
MIX_IN
MIX_GND
AUX_LO–
AUX_LO+
VCO_VCC
LNA_GND
14
LNA_VCC
13 LNA_OUT
2 POST OFFICE BOX 655303 DALLAS, TEXAS 75265


Features TRF1015 RF DOWNCONVERTER D Low-Noise Am plifier (LNA), Radio Frequency (RF) Mix er, and Voltage-Controlled Oscillator ( VCO) D Improved Compression Mode D Conv ersion From RF to Intermediate Frequenc y (IF) on a Single Chip D Suitable for Portable 900-MHz Cellular and Cordless Telephones D Low-Current Consumption Mo de D 20-Pin Plastic Shrink Small Outlin e (SSOP) Package D Application-Selectab le Internal or External Oscillator PD1 PD2 AUX_LO– AUX_LO+ OSC2 VCO_GND OSC 1 VCO_VCC VCO_BYP LNA_GND SLWS021D– JUNE 1996 – REVISED JULY 1998 DB PACK AGE (TOP VIEW) 1 20 MIX_OUT– 2 19 MIX _OUT+ 3 18 MIX_IN 4 17 MIX_GND 5 16 LNA _GND 6 15 LNA_IN 7 14 LNA_VCC 8 13 LNA_ OUT 9 12 LNA_GND 10 11 LNA_GND descrip tion The Texas Instruments (TI™) TRF 1015 is a single-chip RF downconverter suitable for 900-MHz receiver applicati ons. It combines a low-noise amplifier (LNA), a buffered voltage-controlled os cillator (VCO), and an RF mixer into a 20-pin SSOP package requiring very few external components. Minimal power.
Keywords TRF1015, datasheet, pdf, etcTI, RF, DOWNCONVERTER, RF1015, F1015, 1015, TRF101, TRF10, TRF1, Equivalent, stock, pinout, distributor, price, schematic, inventory, databook, Electronic, Components, Parameters, parts, cross reference, chip, Semiconductor, circuit, Electric, manual, substitute




@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site (Privacy Policy & Contact)