HIP0060 Driver Datasheet

HIP0060 Datasheet, PDF, Equivalent


Part Number

HIP0060

Description

50V Quad Low Side Power Driver

Manufacture

Renesas

Total Page 7 Pages
Datasheet
Download HIP0060 Datasheet


HIP0060
DATASHEET
HIP0060
1.5A, 50V Quad Low Side Power Driver with Serial Bus Control and Fault
Protection
FN4045
Rev 0.00
July 1997
Features
• Quad NDMOS Output Drivers in a High Voltage Power
BiMOS Process
• Over-Stress Protection - Each Output
- Over-Current Limiting. . . . . . . . . . . . . . . . . . 1.5A Min
- Internal Zener Drain-to-Gate Over-Voltage Clamp
Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50V Typ
- Thermal Shutdown Protection
- Open-Load Detection
• Low Quiescent Current . . . . . . . . . . . . . . . . . 10mA Max
• Serial Diagnostic Link with SPI Bus
• Diagnostic Interrupt Fault Flag
• 5V CMOS Logic Input Control
• Common Reset for Fault Bits and Output Drivers
• Ambient Operating
Temperature Range . . . . . . . . . . . . . . . . -40oC to 125oC
Applications
• Automotive and Industrial Systems
• Fuel Injection Drivers
• Solenoids, Relays and Lamp Drivers
• Logic and P Controlled Drivers
• Robotic Controls
Description
The HIP0060 is a 5V logic controlled Quad Low Side Power
Driver. The outputs are individually protected for over-current
(OC), over-temperature (OT) and over-voltage (OV). If an OC
short circuit in the output load is sensed (IS) in one output
power driver, that output current will be independently limited
while the other outputs remain in operation. Over-current is
limited by direct gate feedback. Over-voltage protection is pro-
vided by a drain-to-gate zener diode that clamps inductive
switching pulses.
The output drivers are individually controlled through a Gate
Control Latch. Temperature is sensed at each output. If a ther-
mal fault exists, a status flag is set and the output is latched
off. Open-load (OL) and over-temperature (OT) faults sets a
status flag bit as diagnostic output to the SPI bus. For all fault
bits (8), an ORed one-shot interrupt signal is output to the INT
pin. An RST reset clears the fault flags and disables all out-
puts while active. The Serial Peripheral Interface (SPI) bus
pins are the Serial Input (SI), Serial Output (SO), Serial Data
Clock (SCK) and the Chip Select (CS).
The HIP0060 is fabricated in a Power BiMOS IC process, and
is intended for use in automotive and other applications having
a wide range of temperature and electrical stress conditions. It
is particularly suited for driving lamps, relays, and solenoids in
applications where low operating power, high breakdown volt-
age, and higher output current at high temperatures is required.
Ordering Information
PART NUMBER
HIP0060AB
TEMP.
RANGE (oC)
PACKAGE
-40 to 125 24 Ld SOIC
PKG.
NO.
M24.3
Pinout
HIP0060 (SOIC)
TOP VIEW
GND 1
INT 2
INA 3
OUTA 4
GND 5
GND 6
GND 7
GND 8
OUTB 9
INB 10
SI 11
CS 12
24 VDD
23 RST
22 IND
21 OUTD
20 GND
19 GND
18 GND
17 GND
16 OUTC
15 INC
14 SO
13 SCK
Block Diagram
VDD
INA
CHANNEL A
(1 OF 4)
+5V
GATE
CONTROL
LATCH
OPEN LOAD
DETECTOR
OVER TEMP.
DETECTOR
RST
SCK
SI
SO
CS
+
O.T.
BIT
O.L.
BIT
OVER
CURRENT
LIMIT
IS
8-BIT SPI
(SERIAL
DIAG.
REG)
TO
B, C, D
2
2
2 2 22
FROM B, C, D
8 ORed O.T./O.L.
FAULT INPUTS,
ONE-SHOT
MULTI OUTPUT
OUTA
INT
FN4045 Rev 0.00
July 1997
Page 1 of 7

HIP0060
HIP0060
Absolute Maximum Ratings
Max Output Voltage, VOUT (Note 2) . . . . . . . . . . . . . . . . . . . . . VOC
Max Output Load Current, ILOAD (Per Output, Note 3) . . . . . . . . ICL
Logic Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 7V
Logic Supply Voltage, VDD . . . . . . . . . . . . . . . . . . . . . . -0.3V to +7V
Operating Conditions
Ambient Temperature Range . . . . . . . . . . . . . . . . . -40oC to 125oC
Junction Temperature Range . . . . . . . . . . . . . . . . . -40oC to 150oC
Thermal Information
Thermal Resistance (Typical, Notes 1, 4)
JA (oC/W)
SOIC - PC Board Mount, Min. Copper . . . . . . . . . .
60
SOIC - PC Board Mount, 2 sq. in. Copper . . . . . . . .
Maximum Storage Temperature Range -55oC to 150oC
35
Maximum Lead Temperature (Soldering 10s). . . . . . . . . . . . . 300oC
(SOIC - Lead Tips Only)
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. JA is measured with the component mounted on an evaluation PC board in free air.
2. The MOSFET Output Drain is internally clamped with a Drain-to-Gate zener diode that turns on the MOSFET; holding the Drain at the Output
Clamp voltage VOC.
3. The output drive is protected by an internal current limit. The ICL over-current limiting threshold parameter specification defines the maximum
current. The maximum current with all outputs ON may be further limited by dissipation.
4. Device dissipation is based on thermal resistance capability of the package in a normal operating environment. The junction to ambient thermal
resistance of 60oC/W is defined here as a PC Board mounted device with minimal copper. With approximately 2 square inches of copper area
as a heat sink, it is practical to achieve 35oC/W thermal resistance. Further reduction in the thermal resistance can be achieved with additional
PC Board Copper ground area or an external heat sink structure next to the ground leads at the center of the package.
Electrical Specifications VDD = 4.5V to 5.5V, VSS = 0V, TA = -40oC to 125oC; Unless Otherwise Specified
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX
OUTPUTS DRIVERS (DR0 TO DR7)
Output Channel Resistance
rDSON IOUT = 0.5A
- - 0.8
Over-Current Limiting Threshold
ICL
1.5 - 3.5
Output Clamping Voltage
Output Clamping Energy
VOC
40 50 60
EOC 1ms Single Pulse Width, TA = 25oC, - 85 -
(Refer to Figure 3 for SOA Limits).
Output OFF Leakage Current
Open-Load Fault Threshold
Output Rise Time
Output Fall Time
Turn-On Delay
Turn-Off Delay
POWER SUPPLY
ILK
ROLD
tR
tF
tON
tOFF
VOUT = 14.5V
VOUT = 14.5V, Output Off
RL = 30VOUT = 14.5V
RL = 30VOUT = 14.5V
RL = 30VOUT = 14.5V
RL = 30VOUT = 14.5V
- - 180
4 - 200
1 - 12
1 - 12
- - 12
- - 12
Power On Reset Threshold
VDD(POR)
VDD Logic Supply Current
IDD All Outputs ON or OFF
LOGIC INPUTS (INx, SI, SCK, RST, CS)
3.2 - 4.4
- - 10
High Level Input Voltage
Low Level Input Voltage
Input Hysteresis
High Output Voltage, SO, INT
Low Output Voltage, SO
Input Pull-Down Current, INx
Reset Input Pull-Up Current, RST
VIH
VIL
VILHYS
V OL
V OH
IINPD
IRPU
Current Sink = 1.6mA
Current Source = -0.8mA
0.7xVDD
-
-
- - 0.2xVDD
0.8 -
-
- - 0.4
VDD - 0.8
75
-
-
-
250
20 - 120
UNITS
A
V
mJ
A
k
s
s
s
s
V
mA
V
V
V
V
V
A
A
FN4045 Rev 0.00
July 1997
Page 2 of 7


Features DATASHEET HIP0060 1.5A, 50V Quad Low Si de Power Driver with Serial Bus Control and Fault Protection FN4045 Rev 0.00 July 1997 Features • Quad NDMOS Outp ut Drivers in a High Voltage Power BiMO S Process • Over-Stress Protection - Each Output - Over-Current Limiting. . . . . . . . . . . . . . . . . . 1.5A Mi n - Internal Zener Drain-to-Gate Over-V oltage Clamp Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50V Typ - Thermal Shutdown Protection - Open-Load Detection • Low Quiescen t Current . . . . . . . . . . . . . . . . . 10mA Max • Serial Diagnostic Lin k with SPI Bus • Diagnostic Interrupt Fault Flag • 5V CMOS Logic Input Con trol • Common Reset for Fault Bits an d Output Drivers • Ambient Operating Temperature Range . . . . . . . . . . . . . . . . -40oC to 125oC Applications • Automotive and Industrial Systems Fuel Injection Drivers • Solenoids , Relays and Lamp Drivers • Logic and P Controlled Drivers • Robotic Controls Description The HIP0060 is a 5V logic contr.
Keywords HIP0060, datasheet, pdf, Renesas, 50V, Quad, Low, Side, Power, Driver, IP0060, P0060, 0060, HIP006, HIP00, HIP0, Equivalent, stock, pinout, distributor, price, schematic, inventory, databook, Electronic, Components, Parameters, parts, cross reference, chip, Semiconductor, circuit, Electric, manual, substitute




@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site (Privacy Policy & Contact)