P-Channel MOSFET load switches
FPF1007-FPF1009 — IntelliMAX™ Advanced Load Products
FPF1007-FPF1009 IntelliMAX™ Advanced Load Products
Features
1.2...
Description
FPF1007-FPF1009 — IntelliMAX™ Advanced Load Products
FPF1007-FPF1009 IntelliMAX™ Advanced Load Products
Features
1.2 to 5.5 V Input Voltage Range
Typical RON = 30 mΩ at VIN = 5.5 V Typical RON = 40 mΩ at VIN = 3.3 V
Fixed Three Different Turn-on Rise Time 10 µs / 80 µs / 1 ms Low < 10 µA at VIN = 3.3 V Quiescent Current Internal ON Pin Pull Down Output Discharge Function ESD Protection above 8000 V HBM and 2000 V CDM RoHS Compliant
Applications
PDAs Cell Phones GPS Devices MP3 Players Digital Cameras Peripheral Ports Hot-Swap Supplies Notebook Computers
General Description
The FPF1007/8/9 are low RDS P-Channel MOSFET load switches offered in a selection of 10 µs, 80 µs, and 1 ms slew rate turn-on options for transient / in-rush current control. To support trends in mobile application requirements, the minimum operating input voltage has been reduced down to 1.2 V, the input current leakage has been minimized to extend battery life, and the ESD-protection has been designed to withstand a minimum of 8 kV (HBM) and 2 kV (CDM).
The switch is controlled by an active-high logic input (ON pin), allowing direct interface with a low-voltage control signal. An internal ON pin pull-down resistor protects against unintentional device turn-on in the initial state. An on-chip pull-down resistor on the output is enabled when the switch is turned-off and provides quick, robust discharge of the output load.
BOTTOM
Pin 1
TOP
Ordering Information
Part
F...
Similar Datasheet