Programmable Clock Generator
Programmable Clock Generator
5P49V5925
DATASHEET
Description
The 5P49V5925 is a programmable clock generator intended...
Description
Programmable Clock Generator
5P49V5925
DATASHEET
Description
The 5P49V5925 is a programmable clock generator intended for high-performance consumer, networking, industrial, computing, and data-communications applications. Configurations may be stored in on-chip One-Time Programmable (OTP) memory or changed using I2C interface. This is IDT’s fifth generation of programmable clock technology (VersaClock® 5).
The frequencies are generated from a single reference clock. The reference clock can come from one of the two redundant clock inputs. A glitchless manual switchover function allows one of the redundant clocks to be selected during normal operation.
Two select pins allow up to 4 different configurations to be programmed and accessible using processor GPIOs or bootstrapping. The different selections may be used for different operating modes (full function, partial function, partial power-down), regional standards (US, Japan, Europe) or system production margin testing.
The device may be configured to use one of two I2C addresses to allow multiple devices to be used in a system.
Pin Assignment
OUT0_SEL_I2CB VDDO0 VDDD VDDO1 OUT1 NC
CLKIN CLKINB
XOUT XIN/REF
VDDA
CLKSEL
1 24
23
22
21
20
19 18
2 17
3
EPAD
16
4
GND
15
5 14
6 13 7 8 9 10 11 12
VDDO2 OUT2 NC VDDO3 OUT3 NC
Features
Generates up to four independent output frequencies High-performance, low phase noise PLL, < 0.7 ps RMS
typical phase jitter on outputs
Four fractional output dividers (FODs) ...
Similar Datasheet