Power Distribution Controller
HIP1015, HIP1016
Power Distribution Controllers
The HIP1015 and HIP1016 are hot swap power controllers. The HIP1015 is ...
Description
HIP1015, HIP1016
Power Distribution Controllers
The HIP1015 and HIP1016 are hot swap power controllers. The HIP1015 is targeted for a +12V bus whereas the HIP1016 is targeted for +5V applications. Each has an undervoltage (UV) monitoring and reporting with a threshold level ~17% lower than the nominal +12V and +5V.
The HIP1015 has an integrated charge pump allowing control of up to a +12V bus using an external N-channel MOSFET. The HIP1016 can also be used to control much higher positive or negative voltages in a low side controller configuration. Both the HIP1015 and HIP1016 feature programmable Overcurrent (OC) detection, current limiting regulation with time delay to latch off and soft start.
Ordering Information
TEMP. PART NUMBER RANGE (oC)
PACKAGE
HIP1015CB
0 to 85 8 Lead SOIC
HIP1015CB-T
0 to 85
8 Lead SOIC Tape and Reel
HIP1016CB
0 to 85 8 Lead SOIC
HIP1016CB-T
0 to 85
8 Lead SOIC Tape and Reel
PKG. NO. M8.15 M8.15
M8.15 M8.15
Application One - High Side Controller
+ LOAD
-
18
27 HIP1015
3 HIP1016 6
45
PWRON PGOOD
OC
FN4778 Rev 5.00 March 2003
+12V
DATASHEET
FN4778 Rev 5.00 March 2003
Features
HOT SWAP Single Power Distribution Control (HIP1015 for 12V, HIP1016 for 5V and Low Side Switch)
Undervoltage Monitoring and Notification
Overcurrent Fault Isolation Programmable Current Regulation Level Programmable Current Limit Time to Latch-Off Rail to Rail Common Mode Input Voltage Range
(HIP1015) Internal Charge Pump Allows the use of ...
Similar Datasheet