Quad Digitally Potentiometer
DATASHEET
X9400
Low Noise/Low Power/SPI Bus Quad Digitally Controlled Potentiometers (XDCP™)
FN8189 Rev 4.00 September...
Description
DATASHEET
X9400
Low Noise/Low Power/SPI Bus Quad Digitally Controlled Potentiometers (XDCP™)
FN8189 Rev 4.00 September 2, 2015
FEATURES
Four potentiometers per package
64 resistor taps
SPI serial interface for write, read, and transfer
operations of the potentiometer
Wiper resistance, 40 typical at 5V.
Four non-volatile data registers for each
potentiometer
Non-volatile storage of multiple wiper position
Power-on recall. Loads saved wiper position on
power-up.
Standby current < 1µA max
System Analog
VV+C/VC:–:2-.57VV
to to
5.5V +5V
operation
10k, 2.5k end to end resistance
100 yr. data retention
Endurance: 100,000 data changes per bit per
register
Low power CMOS
24 Ld SOIC and 24 Ld TSSOP
Pb-free plus anneal available (RoHS compliant)
DESCRIPTION
The X9400 integrates four digitally controlled potentiometers (XDCPs) on a monolithic CMOS integrated circuit.
The digitally controlled potentiometer is implemented using 63 resistive elements in a series array. Between each element are tap points connected to the wiper terminal through switches. The position of the wiper on the array is controlled by the user through the SPI serial bus interface. Each potentiometer has associated with it a volatile Wiper Counter Register (WCR) and four nonvolatile Data Registers (DR0-3) that can be directly written to and read by the user. The contents of the WCR controls the position of the wiper on the resistor array through the switch...
Similar Datasheet