High voltage USB PD power switch
NX20P5090
High voltage USB PD power switch
Rev. 1 — 14 October 2016
Product data sheet
1. General description
The NX20...
Description
NX20P5090
High voltage USB PD power switch
Rev. 1 — 14 October 2016
Product data sheet
1. General description
The NX20P5090 is an advanced 5 A unidirectional power switch for USB PD. It includes under voltage lockout, over voltage lockout, reverse current protection and over-temperature protection circuits. It is designed to automatically isolate the power switch terminals when a fault condition occurs. Both VBUS and VINT pins have 29 V tolerance in shutdown mode. Two NX20P5090 chips can be used in parallel to support dual power inputs connecting to the same charging circuit.
The device has a default 23 V over voltage protection threshold, and the OVP threshold can be adjusted by using an external resistor divider on OVLO pin. A 15 ms de-bounce time is deployed every time before the device is switched ON, followed by a soft start to limit the inrush current.
Designed for operation from 2.5 V to 20 V, it is used in USB PD power control applications to offer essential protection and enhance system reliability.
NX20P5090 is offered in a small 15 bump, 2.56 x 1.54 x 0.555 mm WLCSP package.
2. Features and benefits
Wide supply voltage range from 2.5 V to 20 V ISW maximum 5 A continuous current 29 V tolerance on both VBUS and VINT pin 30 m (typical) Low ON resistance Adjustable VBUS over voltage protection Built in slew rate control for inrush current limit All time two level reverse-current protection Protection circuitry
Over-Temperature Protection Over-Vol...
Similar Datasheet