QUADRUPLE OPERATIONAL AMPLIFIER
www.ti.com
LM124-SP LM124A-SP
SLOS668A – NOVEMBER 2010 – REVISED JANUARY 2011
QUADRUPLE OPERATIONAL AMPLIFIER
Check for...
Description
www.ti.com
LM124-SP LM124A-SP
SLOS668A – NOVEMBER 2010 – REVISED JANUARY 2011
QUADRUPLE OPERATIONAL AMPLIFIER
Check for Samples: LM124-SP, LM124A-SP
FEATURES
1
QML-V Qualified, SMD 5962-7704301VCA, 5962-9950403VCA and 5962-9950403V9B
Rad-Tolerant: 50 kRad (Si) TID (5962-9950403VCA and 5962-9950403V9B) (1) – TID Dose Rate = 0.01 rad/sec (Si)
Wide Supply Ranges – Single Supply: 3 V to 32 V – Dual Supplies: ±1.5 V to ±16 V
Low Supply-Current Drain Independent of Supply Voltage: 0.8 mA (Typ)
Low Input Bias and Offset Parameters – Input Offset Voltage: 1 mV Typ – Input Offset Current: 2 nA Typ – Input Bias Current: 30 nA Typ
Common-Mode Input Voltage Range Includes Ground, Allowing Direct Sensing Near Ground
(1) Radiation tolerance is a typical value based upon initial device qualification with dose rate = 0.01 rad/sec. Radiation lot acceptance testing is available - contact factory for details.
Differential Input Voltage Range Equal to Maximum-Rated Supply Voltage: ±32 V
Open-Loop Differential Voltage Amplification: 100 V/mV Typ
Internal Frequency Compensation
J PACKAGE (TOP VIEW)
1OUT 1 1IN- 2 1IN+ 3 VCC 4 2IN+ 5 2IN- 6
2OUT 7
14 4OUT 13 4IN12 4IN+ 11 GND 10 3IN+ 9 3IN8 3OUT
DESCRIPTION/ORDERING INFORMATION
These devices consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply over a wide range of voltages. Operation from split supplies also is possible if the differ...
Similar Datasheet