20-bit bus interface D-type latch
74ALVCH16841
20-bit bus interface D-type latch; 3-state
Rev. 3 — 12 September 2018
Product data sheet
1. General descr...
Description
74ALVCH16841
20-bit bus interface D-type latch; 3-state
Rev. 3 — 12 September 2018
Product data sheet
1. General description
The 74ALVCH16841 has two 10-bit D-type latch featuring separate D-type inputs for each latch and 3-state outputs for bus oriented applications. The two sections of each register are controlled independently by the latch enable (nLE) and output enable (nOE) control gates.
When nOE is LOW, the data in the registers appears at the outputs. When nOE is HIGH the outputs are in High-impedance OFF state. Operation of the nOE input does not affect the state of the flip-flops.
The 74ALVCH16841 has active bus hold circuitry which is provided to hold unused or floating data inputs at a valid logic level. This feature eliminates the need for external pull-up or pull-down resistors.
2. Features and benefits
Wide supply voltage range of 1.2 V to 3.6 V CMOS low power consumption Direct interface with TTL levels Current drive ±24 mA at VCC = 3.0 V MULTIBYTE flow-through standard pin-out architecture Low inductance multiple VCC and GND pins for minimize noise and ground bounce All data inputs have bushold Output drive capability 50 Ω transmission lines at 85 °C 3-state non-inverting outputs for bus oriented applications Complies with JEDEC standards:
JESD8-5 (2.3 V to 2.7 V) JESD8B/JESD36 (2.7 V to 3.6 V) ESD protection: HBM ANSI/ESDA/JEDEC JS-001 exceeds 2000 V CDM JESD22-C101E exceeds 1000 V
3. Ordering information
Table 1. Ordering ...
Similar Datasheet