Bridge Rectifier. W10MG Datasheet
• Glass passivated.
• Surge overload rating -50 amperes peak.
• Ideal for printed circuit board.
• Reliable low cost construction utilizing moulded plastic technique results in expensive product.
• Mounting position : Any
• Forward Current: 1.5 Amperes
Maximum Ratings and Electrical Characteristics
Rating at 25°C ambient temperature unless otherwise specified.
Single phase, half wave, 60Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
Symbol W005MG W01MG W02MG W04MG W06MG W08MG W10MG Unit
Max. Recurrent Peak Reverse
Max. RMS Voltage
Max. DC Blocking Voltage
Max. Average Forward
Rectified Current at Ta = 25°C
Peak Forward Surge Current,
Half Sine-wave Super Imposed
on Rated Load
I2t Rating for Fusing (t < 8.3ms)
Max. Forward Voltage Drop Per
Element at 1.5A Peak
Max. Reverse Current at Rated
Tj = 25°C
DC Blocking Voltage Tj = 100°C
Operating Temperature Range
-55 to +150
Storage Temperature Range
Dimensions : Inches (Millimetres)
Part Number Table
Bridge Rectifier Diode, WOBM Series, Single Phase, 50V, 1.5A, W005MG
Bridge Rectifier Diode, WOBM Series, Single Phase, 100V, 1.5A, W01MG
Bridge Rectifier Diode, WOBM Series, Single Phase, 200V, 1.5A, W02MG
Bridge Rectifier Diode, WOBM Series, Single Phase, 400V, 1.5A, W04MG
Bridge Rectifier Diode, WOBM Series, Single Phase, 600V, 1.5A, W06MG
Bridge Rectifier Diode, WOBM Series, Single Phase, 800V, 1.5A, W08MG
Bridge Rectifier Diode, WOBM Series, Single Phase, 1000V, 1.5A, W10MG
Important Notice : This data sheet and its contents (the “Information”) belong to the members of the AVNET group of companies (the “Group”) or are licensed to it. No licence is granted for
the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change
without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness,
any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make
any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or
where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its
negligence. Multicomp Pro is the registered trademark of Premier Farnell Limited 2019.