Programmable 300 mA Camera Flash LED Driver
CAT3612
Programmable 300 mA Camera Flash LED Driver
Description
The CAT3612 is a high−efficiency 1x/1.5x fractional cha...
Description
CAT3612
Programmable 300 mA Camera Flash LED Driver
Description
The CAT3612 is a high−efficiency 1x/1.5x fractional charge pump with programmable current in two LED channels. Each channel delivers accurate regulated current up to 150 mA and make CAT3612 ideal for driving one or two flash LEDs.
Low noise operation is achieved by operating at a constant switching frequency of 1 MHz which allows the use of small external ceramic capacitors. The 1x/1.5x fractional charge pump supports a wide range of input voltages from 3 V to 5.5 V with efficiency up to 90%, and is ideal for Li−Ion battery powered devices.
The EN/DIM logic input provides a 1−wire EZDimt interface for dimming control of the LEDs. When enabled, pulsing the EN/DIM reduces the LED current on each negative edge in 31 linear steps from 150 mA down to zero current.
The device is available in the tiny 12−lead thin DFN 3 mm x 3 mm package with a max height of 0.8 mm.
Features
Dual Matched Regulated LED Channels 300 mA Output Current (150 mA per Channel) 1−wire EZDimt Programmable LED Current 32 Accurate Dimming Levels Power Efficiency up to 90% Fractional Pump 1x/1.5x Low Noise Input Ripple Fixed High Frequency Operation 1 MHz “Zero” Current Shutdown Mode Soft Start and Current Limiting Short Circuit Protection Thermal Shutdown Protection 12−lead TDFN 3 mm x 3 mm Package These Devices are Pb−Free, Halogen Free/BFR Free and are RoHS
Compliant
Applications
Camera Flash Cellular Phones Dig...
Similar Datasheet