Document
MAC15 Series
TRIAC – 400V - 800V
Additional Information
Resources
Accessories
Functional Diagram
Samples
MT 2
MT 1 G
Thyristors Datasheet
RoHS Pb
Description
Designed primarily for full-wave ac control applications, such as solid−state relays, motor controls, heating controls and power supplies; or wherever full−wave silicon gate controlled solid−state devices are needed. Triac type thyristors switch from a blocking to a conducting state for either polarity of applied main terminal voltage with positive or negative gate triggering.
Features
■ Blocking Voltage to 800 V
■ All Diffused and Glass Passivated Junctions for Greater Parameter Uniformity and Stability
■ Small, Rugged, Thermowatt Construction for Low Thermal Resistance, High Heat Dissipation and Durability
■ Gate Triggering Guaranteed in Three Modes (MAC15 Series) or Four Modes (MAC15A Series)
■ These Devices are Pb−Free and are RoHS Compliant
Pin Out
CASE 221A STYLE 4
1 2
© 2021 Littelfuse, Inc.
1
Specifications are subject to change without notice.
Revised: GD. 03/08/21
MAC15 Series
TRIAC – 400V - 800V
Thyristors Datasheet
Maximum Ratings (TJ = 25°C unless otherwise noted)
Rating
Symbol
Value
Unit
Peak Repetitive Off-State Voltage (Note 1) (Gate Open, Sine Wave 50 to 60 Hz, TJ = -40° to 125°C)
MAC15A6G MAC15-8G, MAC15A8G MAC15-10G, MAC15A10G
VDRM, VRRM
400 600 800
V
On-State RMS Current (Full Cycle Sine Wave, 50 to 60 Hz, TC = 80°C) Peak Non-Repetitive Surge Current (One Full Cycle Sine Wave, 60 Hz, TC = 80°C) Preceded and Followed by Rated Current
Peak Gate Voltage (Pulse Width ≤ 1.0 µsec; TC = 90°C) Circuit Fusing Consideration (t = 8.3 ms)
IT (RMS) ITSM
VGM I2t
15
A
150
A
10
V
93
A²sec
Peak Gate Power (TC = 80°C, Pulse Width = 1.0 µs)
PGM
20
W
Peak Gate Current (Pulse Width ≤ 1.0 µsec; TC = 90°C)
IGM
2.0
A
Average Gate Power (t = 8.3 ms, TC = 80°C)
PG (AV)
0.5
W
Operating Junction Temperature Range
TJ
-40 to +125
°C
Storage Temperature Range
Tstg
-40 to +150
°C
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the
Recommended Operating Conditions may affect device reliability.
1. VDRM and VRRM for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage; however, positive gate voltage shall not be applied concurrent with negative potential on the anode. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded.
Thermal Characteristics
Rating
Thermal Resistance,
Junction−to−Case (AC) Junction−to−Ambient
Maximum Lead Temperature for Soldering Purposes, 1/8” from case for 10 seconds
Symbol
RƟJC RƟJA TL
Value 2.0 62.5
260
Unit °C/W
°C
Electrical Characteristics - OFF (TJ = 25°C unless otherwise noted ; Electricals apply in both directions)
Character.