DUAL 1-OF-4 DATA SELECTORS/MULTIPLEXERS
54ACT11253, 74ACT11253 DUAL 1-OF-4 DATA SELECTORS/MULTIPLEXERS
WITH 3-STATE OUTPUTS
SCAS040A – D3110, MARCH 1988 – REVIS...
Description
54ACT11253, 74ACT11253 DUAL 1-OF-4 DATA SELECTORS/MULTIPLEXERS
WITH 3-STATE OUTPUTS
SCAS040A – D3110, MARCH 1988 – REVISED APRIL 1993
Inputs Are TTL-Voltage Compatible 3-State Version of ′ACT11153 Permits Multiplexing From N Lines to
One Line
Performs Parallel-to-Serial Conversion Package Options Include Plastic Small-
Outline Packages, Ceramic Chip Carriers,
and Standard Plastic and Ceramic 300-mil
DIPs
Flow-Through Architecture Optimizes
PCB Layout
Center-Pin VCC and GND Configurations
Minimize High-Speed Switching Noise
t EPIC (Enhanced-Performance Implanted CMOS) 1-mm Process
54ACT11253 . . . J PACKAGE 74ACT11253 . . . D OR N PACKAGE
(TOP VIEW)
A1 B2 1Y 3 GND 4 2Y 5 1G 6 2G 7 2C3 8
16 1C0 15 1C1 14 1C2 13 1C3 12 VCC 11 2C0 10 2C1 9 2C2
54ACT11253 . . . FK PACKAGE (TOP VIEW)
1C2 1C3 NC V CC 2C0
description
Each of these data selectors/multiplexers contains inverters and drivers to supply full binary decoding data selection to the AND-OR gates. Separate output control inputs are provided for each of the two four-line sections.
The 3-state outputs can interface with and drive data lines of bus-organized systems. With all but one of the common outputs disabled (at a high-impedance state), the low-impedance of the single enabled output will drive the bus line to a high or low logic level. Each output has its own strobe (G). The outputs are disabled when G is high.
The 54ACT11253 is characterized for operation
over the full military temperature range o...
Similar Datasheet