LOW-POWER MULTIPLE DRIVERS/RECEIVERS
SN75C185 LOW-POWER MULTIPLE DRIVERS AND RECEIVERS
D Meets or Exceeds the Requirements of
TIA/EIA-232-F and ITU Recommen...
Description
SN75C185 LOW-POWER MULTIPLE DRIVERS AND RECEIVERS
D Meets or Exceeds the Requirements of
TIA/EIA-232-F and ITU Recommendation
V.28
D Single Chip With Easy Interface Between
UART and Serial-Port Connector
D Less Than 9-mW Power Consumption D Wide Driver Supply Voltage . . . 4.5 V to
13.2 V
D Driver Output Slew Rate Limited to
30 V/µs Max
D Receiver Input Hysteresis . . . 1100 mV Typ D Push-Pull Receiver Outputs D On-Chip Receiver 1-µs Noise Filter D Functionally Interchangeable With Texas
Instruments SN75185
D Operates Up to 120 kbit/s Over a 3-Meter
Cable (See Application Information for
Conditions)
SLLS065F – AUGUST 1989 – REVISED JANUARY 2000
DW OR N PACKAGE (TOP VIEW)
VDD 1 RA1 2 RA2 3 RA3 4 DY1 5 DY2 6 RA4 7 DY3 8 RA5 9 VSS 10
20 VCC 19 RY1 18 RY2 17 RY3 16 DA1 15 DA2 14 RY4 13 DA3 12 RY5 11 GND
description
The SN75C185 is a low-power BiMOS device containing three independent drivers and five receivers that are used to interface data terminal equipment (DTE) with data circuit-terminating equipment (DCE). Typically, the SN75C185 replaces one SN75188 and two SN75189 devices. This device conforms to TIA/EIA-232-F. The drivers and receivers of the SN75C185 are similar to those of the SN75C188 and SN75C189A, respectively. The drivers have a controlled output slew rate that is limited to a maximum of 30 V/µs, and the receivers have filters that reject input noise pulses that are shorter than 1 µs. Both these features eliminate the need for external components.
The SN75C18...
Similar Datasheet