16-kbit Add-Only Memory
DS2505 16-kbit Add-Only Memory
www.dalsemi.com
FEATURES
16384 bits Electrically Programmable Read Only Memory (EPROM) c...
Description
DS2505 16-kbit Add-Only Memory
www.dalsemi.com
FEATURES
16384 bits Electrically Programmable Read Only Memory (EPROM) communicates with the economy of one signal plus ground Unique, factory-lasered and tested 64-bit registration number (8-bit family code + 48-bit serial number + 8-bit CRC tester) assures absolute traceability because no two parts are alike Built-in multidrop controller ensures compatibility with other 1-Wire Net products EPROM partitioned into sixty-four 256-bit pages for randomly accessing packetized data records Each memory page can be permanently writeprotected to prevent tampering Device is an “add only” memory where additional data can be programmed into EPROM without disturbing existing data Architecture allows software to patch data by superseding an old page in favor of a newly programmed page Reduces control, address, data, power, and programming signals to a single data pin Directly connects to a single port pin of a microprocessor and communicates at up to 16.3 kbits per second 8-bit family code specifies DS2505 communications requirements to reader Presence detector acknowledges when the reader first applies voltage Low cost TO-92 or 6-pin TSOC surface mount package Reads over a wide voltage range of 2.8V to 6.0V from -40°C to +85°C; programs at 11.5V to 12.0V from -40°C to +50°C
PIN ASSIGNMENT
TO-92
DALLAS DS2505
TSOC PACKAGE
GND DATA NC 1 2 3 6 5 4 NC NC NC
Top View 3.7 X 4.0 X 1.5 mm
Side View See Mech. Drawing Section
GND DATA NC
1 2 3 B...
Similar Datasheet