35.42MHz SAW Filter for GPS Receivers
DW9255 DW9255
35.42MHz SAW Filter for GPS Receivers
DS3861 - 3.1 November 1997
OUTPUT+
OUTPUT-
The DW9255 is a Surfa...
Description
DW9255 DW9255
35.42MHz SAW Filter for GPS Receivers
DS3861 - 3.1 November 1997
OUTPUT+
OUTPUT-
The DW9255 is a Surface Acoustic Wave (SAW) bandpass filter for use with the GP2000 Global Positioning System (GPS) receiver chip-set, available from Mitel Semiconductor. It is pre-tuned to the exact 2nd IF filter requirements of the GP2010 & GP2015 RF front-end devices, with a centrefrequency of 35.42MHz. The response is tuned for a flat passband, steep stopband and uniform passband group-delay with 3 external inductors. The device is realised on a Lithium Tantalate substrate and housed in a small leadless ceramic Surface Mount package. The DW9255 gives significant improvement in correlated GPS Signal-to-Noise Ratio (SNR) performance compared to conventional LC bandpass filter schemes. This aids satellite signal acquisition and tracking capability from the GP2000 GPS chip-set. This device effectively filters out-of-band (unwanted) noise in the GPS signal. The Automatic Gain Control (AGC) within the GP2010 and GP2015 RF Front-end devices will then operate only on in-band noise for optimum gain and superior correlated GPS signal strength.
INPUT+
2 GND 3
INPUT1 12 GND 11
GND
4
GND
DW9255
GND 5 10 GND
GND
6 7 8
9
GND
LCS12/1
FEATURES
INPUT +
s Insertion Loss of 17dB ±1dB (typical) s 1dB Bandwidth 1.9MHz (typical) s Passband Ripple 0.8dB (typical) s Low Profile Ceramic Surface Mount Package s Operating Temperature Range -40° to +85°C
GND 3
2
INPUT -
s Centre Frequen...
Similar Datasheet