18-Bit Universal Bus Transceivers
74ABT16500 18-Bit Universal Bus Transceivers with 3-STATE Outputs
April 1993 Revised January 1999
74ABT16500 18-Bit Un...
Description
74ABT16500 18-Bit Universal Bus Transceivers with 3-STATE Outputs
April 1993 Revised January 1999
74ABT16500 18-Bit Universal Bus Transceivers with 3-STATE Outputs
General Description
The ABT16500 18-bit universal bus transceiver combines D-type latches and D-type flip-flops to allow data flow in transparent, latched, and clocked modes. Data flow in each direction is controlled by output-enable (OEAB and OEBA), latch-enable (LEAB and LEBA), and clock (CLKAB and CLKBA) inputs. For A-to-B data flow, the device operates in the transparent mode when LEAB is HIGH. When LEAB is LOW, the A data is latched if CLKAB is held at a HIGH or LOW logic level. If LEAB is LOW, the A bus data is stored in the latch/flip-flop on the HIGH-to-LOW transition of CLKAB. Output-enable OEAB is active-high. When OEAB is HIGH, the outputs are active. When OEAB is LOW, the outputs are in the high-impedance state. Data flow for B to A is similar to that of A to B but uses OEBA, LEBA, and CLKBA. The output enables are complementary (OEAB is active HIGH and OEBA is active LOW). To ensure the high-impedance state during power up or power down, OE should be tied to GND through a pulldown resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver.
Features
s Combines D-Type latches and D-Type flip-flops for operation in transparent, latched, or clocked mode s Flow-through architecture optimizes PCB layout s Guaranteed latch-up protection s High impedance glitc...
Similar Datasheet