S6B0719

S6B0719 160 SEG / 105 COM SEG DRIVER & CONTROLLER FOR STN LCD Jan. 2000. Ver. 0.4 Prepared by: Koo-Hyung, Jung [email protected] Contents in this document are subject to change without notice. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of LCD Driver IC Team. 160 SEG / 105 COM DRIVER & CONTROLLER FOR STN LCD PRELIMINARY SPEC. VER. 0.4 S6B0719 S6B0719 Specification Revision History Version 0.0 0.1 0.2 0.3 0.4 Original Append pad center coordinate (refer to table 2) Append display data RAM map (refer to figure 8) Modify display data RAM map (refer to figure 8) Append reference circuit examples (refer to page 22) Change the low power consumption V0 = 13V -> 15V (refer to page 1) Modify page address circuit description ; DB3, DB2 and DB1 are “ H” , but DB1 is “L” -> DB3, DB2 and DB0 are “H”, but DB1 is “L” (refer to page 20) Modify set partial display duty ratio (refer to page 27) Add partial duty changing “waiting for discharging the LCD power levels (refer to figure 34) Change the condition of power consumption : (VDD = 3V, x6 boosting, V0 = 15V) → (VDD = 3V, x5 boosting, V0 = 13V) (refer to page 1) Change the absolute maximum ratings of V0 and VOUT : 20V → 17V (refer to page 50) Change the operating voltage of V0 and VOUT : 17V → 15V (refer to page 1 and 51) Change the operating voltage of VDD : (2.4 to 5.5V) → (2.4 to 3.6V) (refer to page 1...