CCD Signal Processors for B/W CCD Cameras
IR3Y30M/M1
IR3Y30M/M1
DESCRIPTION
The IR3Y30M/M1 are bipolar single-chip signal processing ICs with built-in low-pass f...
Description
IR3Y30M/M1
IR3Y30M/M1
DESCRIPTION
The IR3Y30M/M1 are bipolar single-chip signal processing ICs with built-in low-pass filter and delay line for B/W video cameras. They realize both downsizing and cost reduction of the finished set.
CCD Signal Processors for B/W CCD Cameras
FEATURES
Low power consumption : 265 mW (TYP.) Wide AGC range : –3 to +29 dB High speed sample-and-hold circuits : pulse width 15 ns (MIN.) Signal processing from CCD output to 75 $ video output is possible Built-in low-pass filter Built-in comparator for electronic exposure control Built-in aperture circuit and delay line Single +5 V power supply Packages – IR3Y30M : 48-pin QFP (QFP048-P-1010) – IR3Y30M1 : 48-pin QFP (QFP048-P-0707) 0.5 mm pin-pitch
COMPARISON TABLE
Package Power consumption PD derating ratio Operating temperature IR3Y30M 48-pin QFP (QFP048-P-1010) 725 mW 5.8 mW/˚C –30 to +75 ˚C IR3Y30M1 48-pin QFP (QFP048-P-0707) 560 mW 4.5 mW/˚C –30 to +70 ˚C
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
1
IR3Y30M/M1
PIN CONNECTIONS
48-PIN QFP
PGND FCDS FS PVCC CDS OUT CLAMP1 AGC OP IN MAX GAIN AGC OP OUT AGC CTRL VC VREF
TOP VIEW
48 47 46 45 44 43 42 41 40 39 38 37 CCD IN 1 CLAMP BIAS 2 IRIS GAMMA 3 WINDOW 4 IRIS OUT 5 VCC1 6 ...
Similar Datasheet