X25F087

8K X25F087 SPI SerialFlash with Block LockTM Protection DESCRIPTION 1024 x 8 Bit FEATURES 1MHz Clock Rate SPI Modes (0,0 & 1,1) 1024 x 8 Bits —16 Byte Small Sector Program Mode Low Power CMOS —<1µA Standby Current —<3mA Active Current during Program —<400µA Active Current during Read 1.8V to 3.6V or 5V “Univolt” Read and Program Power Supply Versions Block Lock Protection —Block Lock Protect 0, any 1/4, 1st 1/2, First or Last Sector of SerialFlash Array Built-in Inadvertent Program Protection —Power-Up/Power-Down Protection Circuitry —Program Enable Latch —Program Protect Pin Self-Timed Program Cycle —5ms Program Cycle Time (Typical) High Reliability —Endurance: 100,000 Cycles/Byte —Data Retention: 100 Years —ESD: 2000V on all pins 8-Lead SOIC Package 8-Lead TSSOP Package 8-Pin Mini-DIP Package FUNCTIONAL DIAGRAM SI SO COMMAND DECODE AND CONTROL LOGIC The X25F087 is a CMOS 8k-bit SerialFlash, internally organized as 1024 x 8. The X25F087 features a Serial Peripheral Interface (SPI) and software protocol allowing operation on a simple four-wire bus. The bus signals are a clock input (SCK) plus separate data in (SI) and data out (SO) lines. Access to the device is controlled through a chip select (CS) input, allowing any number of devices to share the same bus. There are eight options for programmable, nonvolatile, Block Lock Protection available to the end user. These options are implemented via special instructions programmed to the part. The X25F0...