3V CDMA DRIVER AMPLIFIER
Preliminary
RF2352
3V CDMA DRIVER AMPLIFIER
4
Typical Applications
• TDMA/CDMA/FM Driver Amplifier • Low Noise Transmi...
Description
Preliminary
RF2352
3V CDMA DRIVER AMPLIFIER
4
Typical Applications
TDMA/CDMA/FM Driver Amplifier Low Noise Transmit Driver Amplifier
General Purpose Amplification Commercial and Consumer Systems
Product Description
3.75
2 0.45 0.28 0.75 0.50 0.80 TYP 1
1
4
GENERAL PURPOSE AMPLIFIERS
The RF2352 is a low noise driver amplifier for 900MHz CDMA/AMPS applications. The device is designed for operation from 2.7V to 3.6V, and features selectable high and low gain modes. In high gain mode, the device will provide about 19dB of gain, and the linearity and current drain are set with an external resistor, allowing the designer to select the optimum performance for a given application. In the low gain, or “bypass” mode, the gain is controlled by an external attenuator network, and the device draws essentially no current. The part is fabricated using a high performance silicon BiCMOS process, and is packaged in a 4mmx4mm, 16-pin, leadless chip carrier.
3.75
+
1.60 4.00
12° 1.50 SQ INDEX AREA 3 3.20 4.00 1.00 0.90
0.75 0.65
NOTES:
1 Shaded Pin is Lead 1. 2 Dimension applies to plated terminal and is measured between 0.10 mm and 0.25 mm from terminal tip.
0.05 0.00
The terminal #1 identifier and terminal numbering convention 3 shall conform to JESD 95-1 SPP-012. Details of terminal #1 identifier are optional, but must be located within the zone indicated. The identifier may be either a mold or marked feature. 4 5 Pins 1 and 9 are fused. Package Warpage: 0.05 max.
Opt...
Similar Datasheet