TELEPHONE TONE RINGER WITH BRIDGE DIODE
WS2418
TELEPHONE TONE RINGER WITH BRIDGE DIODE
8 DIP
The WS2418 is a monolithic integrated circuit telephone tone ring...
Description
WS2418
TELEPHONE TONE RINGER WITH BRIDGE DIODE
8 DIP
The WS2418 is a monolithic integrated circuit telephone tone ringer with bridge diode, when coupled with an appropriate transducer, it replaces the electromechanical bell. This device is designed for use with either a piezo transducer or an inexpensive transformer coupled speaker to produce a pleasing tone composed of a high frequency (fR) alternating with a low frequency (fL) resulting in a warble frequency. The supply voltage is obtained from the AC ring signal and the circuit is designed so that noise on the line or variation of the ringing signal cannot affect correct operating of the device.
FEATURES
! ! ! ! ! ! ! ! ! ! On chip high voltage full wave diode bridge rectifier Low current consumption, in order to allow the parallel operation of the 4device Low external component count Tone and switching frequencies adjustable by external components High noise immunity due to built-in voltage current hysteresis Activation voltage adjustable Internal zener diodes to protect against over voltages Ringer impedance adjustable with external components Electronic telephone ringers Extension ringers
WS2418
BLOCK DIAGRAM
RECTIFIER CAPACITOR ACTIVATION VOLTAGE ADJUSTABLE
7
TIP
6
8
POWER SUPPLY CONTROL CIRCUIT
LOW FREQ OSC
HIGH FREQ OSC
OUTPUT AMP
5
OUTPUT
RING
1
2
GND
3
4
SWEEP RATE OUTPUT FREQUENCY CONTROL CAPACITOR CONTROL RESISTOR
ABSOLUTE MAXIMUM RATINGS (TA=25℃)
SYMBOL
VC VC(ON-OFF) ICC TOPR TSTG
CHARACTERIS...
Similar Datasheet