Document
0
R
QPRO Family of XC1700D QML Configuration PROMs
0 2
DS070 (v2.1) June 1, 2000
Product Specification
Features
• • • Certified to MIL-PRF-38535 Appendix A QML (Qualified Manufacturer Listing.) Also available under the following Standard Microcircuit Drawings (SMD): 5962-94717 and 5962-95617. Configuration one-time programmable (OTP) read-only memory designed to store configuration bitstreams of Xilinx FPGA devices On-chip address counter, incremented by each rising edge on the clock input Simple interface to the FPGA requires only one user I/O pin Cascadable for storing longer or multiple bitstreams Programmable reset polarity (active High or active Low) for compatibility with different FPGA solutions Low-power CMOS EPROM process Available in 5V version only Programming support by leading programmer manufacturers. Design support using the Xilinx Alliance and Foundation series software packages.
Description
The XC1700D QPRO™ family of configuration PROMs provide an easy-to-use, cost-effective method for storing Xilinx FPGA configuration bitstreams. When the FPGA is in Master Serial mode, it generates a configuration clock that drives the PROM. A short access time after the rising clock edge, data appears on the PROM DATA output pin that is connected to the FPGA D IN pin. The FPGA generates the appropriate number of clock pulses to complete the configuration. Once configured, it disables the PROM. When the FPGA is in Slave Serial mode, the PROM and the FPGA must both be clocked by an incoming signal. Multiple devices can be concatenated by using the CEO output to drive the CE input of the following device. The clock inputs and the DATA outputs of all PROMs in this chain are interconnected. All devices are compatible and can be cascaded with other members of the family. For device programming, either the Xilinx Alliance™ or the Foundation™ series development systems compiles the FPGA design file into a standard HEX format which is then transferred to most commercial PROM programmers.
• • • • • • • •
VCC
VPP
GND
RESET/ OE or OE/ RESET
CE
CEO
CLK
Address Counter
TC
EPROM Cell Matrix
Output
OE DATA
DS027_01_021500
Figure 1: Simplified Block Diagram (does not show programming circuit)
© 2000 Xilinx, Inc. All rights reserved. All Xilinx trademarks, registered trademarks, patents, and disclaimers are as listed at http://www.xilinx.com/legal.htm. All other trademarks and registered trademarks are the property of their respective owners. All specifications are subject to change without notice.
DS070 (v2.1) June 1, 2000 Product Specification
www.xilinx.com 1-800-255-7778
1
QPRO Family of XC1700D QML Configuration PROMs
R
Pin Description
DATA
Data output, 3-stated when either CE or OE are inactive. During programming, the DATA pin is I/O. Note that OE can be programmed to be either active High or active Low.
ation, this pin must be connected to VCC. Failure to do so may lead to unpredictable, temperature-dependent operation and s.