TONE RINGER WITH BRIDGE DIODE
KA2418B/28
INTRODUCTION
TONE RINGER WITH BRIDGE DIODE
The KA2418B/28 is a monolithic integrated circuit telephone tone...
Description
KA2418B/28
INTRODUCTION
TONE RINGER WITH BRIDGE DIODE
The KA2418B/28 is a monolithic integrated circuit telephone tone ringer with bridge diode, when coupled with an appropriate transducer, it replaces the electromechanical bell. This device is designed for use with either a piezo transducer or an inexpensive transformer coupled speaker to produce a pleasing tone composed of a high frequencys (fH1, fH2) alternating with a low frequency (fS) resulting in a warble frequency. The supply voltage is obtained from the AC ring signal and the circuit is designed so that noise on the line or variation of the ringing signal can not affect correct operation of the device.
8-DIP-300
FEATURES
Built-in full wave bridge diode rectifier Low current consumption, in order to allow the parallel operation of the 4 devices Few external components Tone and adjustable switching frequencies by external components High noise immunity due to built-in voltage to current hysteresis Adjustable activation voltage Internal zener diodes to protect against over voltages Adjustable ringer impedance with external components.
ORDERING INFORMATION
Device KA2418B KA2428 Package 8-DIP-300 Operating Temperature - 20°C ~ + 70°C
APPLICATIONS
Electronic telephone ringers Extension ringers
BLOCK DIAGRAM
RECTIFIER CAPACITOR 7 ACTIVATION VOLTAGE ADJUSTABLE 6
TIP
8
-
+
POWER SUPPLY CONTROL CIRCUIT
LOW FREQ OSC
HIGH FREQ OSC
OUTPUT AMP
5 OUTPUT
RING
1
2 GND
3 SWEEP RATE CONTROL CAPAC...
Similar Datasheet